Xerox 6110MFP manual Selecting a location, Printing a demo, Altitude adjustment, Clearance space

Selecting a location

Select a level, stable place with adequate space for air circulation. Allow extra space for opening covers and trays.

The area should be well-ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not set the machine close to the edge of your desk or table.

Clearance space

• Front: 482.6 mm

(enough space so that the paper tray can be removed)

•Back: 100 mm (enough space for ventilation)

•Right: 100 mm (enough space for ventilation)

•Left: 100 mm (enough space for ventilation)

Tip

When you move the printer, do not tilt or turn it upside down. Or the inside of the printer may be contaminated by toner, which can cause damage to the printer or bad printing quality.

Place the machine on a flat and stable surface not letting it lean more than 2 mm (0.08 inches). Otherwise, it may affect the printing quality.

Printing a demo page

Print a demo page to make sure that the machine is operating correctly.

To print a demo page:

In Ready mode, press and hold the Enter button for about 2 seconds.

Altitude adjustment

The print quality is affected by atmospheric pressure, which is determined by the height of the machine above sea level. The following information will guide you on how to set your machine to the best print quality or best quality of print.

Before you set the altitude value, find the altitude where you are using the machine.

Value

1 High 3

2 High 2

3 High 1

4 Normal

0

1Ensure that you have installed the printer driver with the provided Printer Software CD.

2Click the Windows Start menu.

3Click Printer Setting Utility.

4Click Settings > Altitude Adjustment. Select the appropriate value from the dropdown list, and then click Apply.

1.5 <Introduction>