Xerox 6110MFP manual To avoid damaging the machine, use only

Media type		Guidelines
	•	To avoid damaging the machine, use only
		transparencies designed for use in laser
		printers.
	•	Transparencies used in the printer must be able
		to withstand the machine’s fusing temperature.
		Check your machine’s specification to view the
		fusing temperature, see page 13.1.
	•	Place them on a flat surface after removing
		them from the machine.
	•	Do not leave them in the paper tray for long
		periods of time. Dust and dirt may accumulate
		on them, resulting in spotty printing.
Transparencies	•	To avoid smudging caused by fingerprints,
		handle them carefully.
	•	To avoid fading, do not expose printed
		transparencies to prolonged sunlight.
	•	Ensure that transparencies are not wrinkled,
		curled, or have any torn edges.

Caution

Recommended media: Transparency for a Color Laser Printers produced by Xerox. It is not recommended to use paperbacked transparencies such as Xerox 3R91334, which can cause a jam or be scratched.

Media type		Guidelines
	• To avoid damaging the machine, use only labels
		designed for use in laser printers.
	• When selecting labels, consider the following
		factors:
		- Adhesives: The adhesive material should be
		stable at your machine’s fusing temperature.
		Check your machine’s specification to view the
		fusing temperature, see page 13.1.
		- Arrangement: Only use labels with no exposed
		backing between them. Labels can peel off
		sheets that have spaces between the labels,
		causing serious jams.
		- Curl: Prior to printing, labels must lie flat with no
Labels		more than 13 mm (5 inches) of curl in any
		direction.
		- Condition: Do not use labels with wrinkles,
		bubbles, or other indications of separation.
	•	Make sure that there is no exposed adhesive
		material between labels. Exposed areas can cause
		labels to peel off during printing, which can cause
		paper jams. Exposed adhesive can also cause
		damage to machine components.
	• Do not run a sheet of labels through the machine
		more than once. The adhesive backing is designed
		for only a single pass through the machine.
	• Do not use labels that are separating from the
		backing sheet or are wrinkled, bubbled, or
		otherwise damaged.
	•	Do not print on media smaller than 76 mm
Card stock or		(3.00 inches) wide or 127 mm (5.00 inches) long.
custom-sized	•	In the software application, set margins at least
materials		6.4 mm (0.25 inches) away from the edges of
		the material.
	•	Letterhead must be printed with heat-resistant
		ink that will not melt, vaporize, or release
		hazardous emissions when subjected to the
		printer’s fusing temperature for 0.1 second.
		Check your machine’s specification to view the
		fusing temperature, see page 13.1.
Preprinted	•	Letterhead ink must be non-flammable and
		should not adversely affect printer rollers.
paper
	•	Forms and letterhead should be sealed in a
		moisture-proof wrapping to prevent changes
		during storage.
	• Before you load preprinted paper, such as forms
		and letterhead, verify that the ink on the paper is
		dry. During the fusing process, wet ink can come
		off preprinted paper, reducing print quality.

4.4 <Selecting and loading print media>