11-8 Operating the Fiery SI
If you press a button, the following options appear:

Restarting the Fiery SI

You should use the procedure described in this section to restart the Fiery SI rather
than using the power switch on the rear of the Fiery SI.
TO RESTART THE FIERY SI:
1. Make sure that the Fiery SI is not receiving, processing, or printing a document.
Make sure that the status message on the Control Panel is Idle.
NOTE:If a job from the Print Queue is processing, it will continue processing and print
after the Fiery SI is restarted; if a job sent to the direct connection is processing, it will
not finish processing or printing.
2. Press the Menu button to display the Functions menu.
3. Use the down arrow button to scroll to the last screen and choose Reboot Server.
Choose: To do this:
Run Setup View the options in the Setup menus. For information on
these settings, see the Administrator Guide.
Install Software Install new system software. This should be done only by
your Fiery SI service representative.
Format Disk Reformat the Fiery SI hard disk. This should be done only
by your Fiery SI service representative.