Function Selection via the Line

Xerox FS 5250, User’s Guide

8.7.Commands for Storing and Restoring Settings

The commands listed below permit you to read and save the settings in the NVRAM area. You may also read the factory defaults.

Please observe that when one of the commands below are used, the temporary escape character, if any, will be removed.

Command

Description

Example

%X1

This command is needed

You send the

 

to save settings in the

command as follows:

 

interface memory.

&&??% %X1

 

Without the %X1, change

 

 

 

of settings will be lost at

 

 

power off.

 

%X3

Read and activate factory

You send the

 

default settings.

command as follows:

 

Use this command if you

 

 

have changed many

&&??% %X3

 

settings and wish to start

 

 

all over again.

 

%X4

Read and activate the

You send the

 

permanent settings.

command as follows:

 

Use this command if you

 

 

have changed a couple of

&&??% %X4

 

settings temporarily for a

 

 

specific purpose. When

 

 

you have used the

 

 

temporary settings, you

 

 

can erase them again by

 

 

sending the X4 command.

 

 

You will then be back in

 

 

the settings programmed

 

 

into the interface.

 

 

 

 

- 32 -

Page 32
Image 32
Xerox FS 5250 Commands for Storing and Restoring Settings, Command Description Example, ??% %X1, ??% %X3, ??% %X4