Xerox 92C, IPS, NPS, 4890, 4850 manual Profiles for third-partyfinishing devices, Mechanical interface

Printer components and options

Profiles for third-party finishing devices

When a bypass transport is connected to the NPS/IPS, you can add any number of third-party finishing devices.

1 2 3

Figure 3-9. Third-party finishing device configuration

1.Paper path

2.Bypass transport

3.Third-party finishing devices

Each third-party device is identified by a specific personality profile. The personality profile contains information about the options available with the finishing device (for example, a booklet-making device that can produce both side-stitched and saddle-stitched booklets). It also specifies timing requirements, constraints, flags, and other parameters.

You can create several personality profiles that correspond to different configurations of the finishing device. Refer to your Guide to Configuring and Managing the System for information on creating personality profiles.

Mechanical interface

To connect a third-party finishing device to the NPS/IPS bypass transport, you align the finishing device with the paper exit slot of the bypass transport, dock the finishing device, and establish an electrical interface between the two.

Connecting the bypass transport to third-party finishing devices involves the following:

3-13 System Overview Guide