Xerox 4850, IPS, NPS, 4890, 92C manual Operator tasks for the bypass transport

Printer components and options

Software, firmware, hardware, and paper requirements

The optional bypass transport requires the following:

•Dual stacker output module

•Standard white, colored, predrilled, or preprinted paper. To minimize paper jams and misfeeds, use 20 pound or 80 gsm (grams per square meter) bond xerographic grade. Xerox 4024 Dual Purpose Paper and Xerox 10 Series Dual Purpose paper are optimal. Use paper with less than 6% moisture content so that the paper will not curl and jam.

NOTE: The time between sheets exiting the bypass transport for

8.5by 11-inch / 216 by 279 mm paper, A4 paper, and 8.5 by 14- inch / 216 by 352 mm paper is 492 milliseconds in simplex mode and 1052 milliseconds in duplex mode. All times are measured between the trail edge of the exiting sheet and the lead edge of the next entering sheet.

Operator tasks for the bypass transport

To use the bypass transport and third-party finishing devices, you must perform several tasks:

•Install and remove the bypass transport.

•Set up DFA personality profiles to provide the NPS/IPS with information about each finishing device.

•Prepare the finishing device hardware necessary to finish the printed output and inform the NPS/IPS of device names and parameters.

•Enter appropriate commands at the printer controller to initiate finisher jobs.

•Clear paper jams in the bypass transport.

You learn how to install and remove the bypass transport and clear jams in the operator training that is provided by Xerox following installation of the bypass transport.

In addition, you must know how to prepare the third-party finishing device to process printed output. Obtain this information from your third-party supplier.

3-12 System Overview Guide