Xerox NPS, IPS, 4890 Printer components and options, Sample button The sample feature is not used

Printer components and options

Power on/off This switch controls power to the printer and is used primarily by switch service representatives.

Sample button The sample feature is not used.

Continue button The Continue button resumes printing when it is pressed.

While it is formatting a complex page, the printer controller may cycle down the printer if the page image is not available within a certain amount of time. If this occurs, the following message appears:

Press <CONTINUE> to resume printing

You can ignore this message. As soon as the page image is available, the printer controller cycles up the printer and printing automatically resumes.

Stop button Pressing the Stop button halts printing.

Fault code display When enabled by a service representative, shows the number of completed prints and printer fault codes. When a fault code displays here, the corresponding message appears in the message display.

Information button When “i” appears on the message display, you can press this button for additional information on printer operation. You can press the button repeatedly for more information as long as “i” appears.

Sample tray This output tray receives sample prints of system files, rejected prints, and transparencies. The capacity of the sample tray is 100 sheets of 20-pound or 80 gsm bond. There is no tray full sensor, therefore, empty this tray regularly to avoid paper jams.

Dual stacker trays Each output stacker tray has a capacity of 750 sheets of 20-

1 and 2 pound or 80 gsm bond (1500 sheets total capacity). An alternate to the dual stacker configuration is the stitcher/stacker.

Feeder trays The standard configuration contains two feeder trays with the following capacities (based on 20-pound or 80 gsm bond):

•Tray 1: 1000 sheets

•Tray 2: 500 sheets. (Except for capacity, this tray is identical to tray 1.)

System Overview Guide 3-5