TROUBLESHOOTING
Problem | Cause | Remedy | Refer |
|
|
| to page |
|
|
|
|
No sound from the | The output level of the center speaker is set to | Raise the level of the center speaker. | 40 |
minimum. |
|
| |
center speaker. |
|
| |
|
|
| |
| “1A CENTER” on the SET MENU is set to | Select the appropriate mode for your center | 36 |
| NON. | speaker. |
|
|
|
|
|
| One of the | Select another DSP program. | 21 – 22 |
| been selected (except for 5ch Stereo). |
|
|
|
|
|
|
| The source encoded with a Dolby Digital or |
| — |
| DTS signal does not have a center channel |
|
|
| signal. |
|
|
|
|
|
|
No sound from the | The output level of the rear speakers is set to | Raise the output level of the rear speakers. | 40 |
rear speakers. | minimum. |
|
|
|
|
|
|
| A monaural source is being played with | Select another DSP program. | 21 – 22 |
| program 9. |
|
|
|
|
|
|
No sound from the | “1D BASS” on the SET MENU is set to | Select SWFR or BOTH. | 37 |
subwoofer. | FRONT when a Dolby Digital or DTS signal |
|
|
| is being played. |
|
|
|
|
|
|
| “1D BASS” on the SET MENU is set to | Select BOTH. | 37 |
| SWFR or FRONT when a |
|
|
| being played. |
|
|
|
|
|
|
| The source does not contain low bass signals |
| — |
| (90 Hz and below). |
|
|
|
|
|
|
Poor bass | The speaker mode settings (front, center, or | Select the appropriate position for each speaker | 36 – 37 |
reproduction. | rear) on the SET MENU do not match your | based on the size of the speakers in your |
|
| speaker configuration. | configuration. |
|
|
|
|
|
A “humming” sound | Incorrect cable connections to the analog | Firmly connect the audio plugs to the analog | 12 – 13 |
can be heard. | audio jacks. | audio jacks. If the problem persists, the cables |
|
|
| may be defective. |
|
|
|
|
|
The volume level | The component connected to the output (VCR | Turn on the power to the component. | — |
cannot be increased, | OUT) jacks of this system is turned off. |
|
|
or the sound is |
|
|
|
distorted. |
|
|
|
|
|
|
|
The sound effect | It is not possible to record the sound effect by |
| — |
cannot be recorded. | a recording component. |
|
|
|
|
|
|
This system does | The internal microcomputer has been frozen | Disconnect the AC power cord from the outlet | — |
not operate properly. | by an external electric shock (such as | and then plug it in again after about 30 seconds. |
|
| lightning or excessive static electricity) or by |
|
|
| a power supply with low voltage. |
|
|
|
|
|
|
There is noise | This system is too close to the digital or high- | Move this system further away from such | — |
interference from | frequency equipment. | equipment. |
|
digital or high- |
|
|
|
frequency equipment, |
|
|
|
or this system. |
|
|
|
|
|
|
|
44
