Yamaha AVX-S80 owner manual Setting the manufacturer code, Precautions when performing the setting

OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL

Setting the manufacturer code (remote control signal assigned to each manufacturer) for your TV, VCR or DVD player on the remote control allows you to operate not only the AVX-S80 but also your TV, VCR or DVD player using the remote control.

Note

•Depending on the model, certain components from other manufacturers cannot be controlled, or only limited functions can be controlled, even though the proper manufacturer code has been set. If you encounter this problem, please use the remote control supplied with the component.

2 Keeping CODE SET pressed, enter the 1- digit device code and the 2-digit manufacturer code for the component to be controlled using the numeric buttons.

You can release CODE SET after entering the code.

y

•The manufacturer code 99 has been set for the remote control selector buttons (TV, VCR and DVD/CD) at the factory.

3 Press POWER (TV or AV) and check that the component to be controlled turns on and off (standby).

Setting the manufacturer code

Manufacturer codes can be set for TV, VCR and DVD/CD buttons only.

Note

•TV manufacturer codes can be set for the TV button only. However, any of the manufacturer codes can be set for the VCR and DVD/CD buttons.

TV	POWER			POWER	AV
	TV	AV	SLEEP
		TV MODE
		INPUT		TUNER
	CH		VOL		VCR
		MUTE		VCR
	SUBTITLE		AUDIO
	REC			VIDEO 2
				VIDEO 1
				CD	DVD/CD
				DVD
CODE SET		CODE SET		AMP
	HALL	JAZZ	ROCK	ENTERTAINMENT
	1	2	3	4

SPORTS	MONO MOVIE		MOVIE 1	MOVIE 2	Numeric buttons
5	6		7	8
/DTS	SELECT		MATRIX 6.1	STEREO
9	0		10	CANCEL
TOP MENU		MENU
LEVEL		SET MENU		MUTE
	PRESET		ABCDE
CH	ENTER		CH
	PRESET
TEST		B.BOOST		VOL
ON SCREEN		RETURN

Precautions when performing the setting

You can operate the component using the TV, VCR or DVD player operation buttons on the remote control once the manufacturer code is set properly. If unsuccessful, perform the procedure from step 1 again. Pay attention to the following points when you perform the procedure.

•Check that the correct remote control selector button has been selected when setting the manufacturer code.

•If more than one code is given for a manufacturer, try entering each code in the order given.

•Remove and replace the remote control’s batteries (complete this step within 2 minutes) and then perform the procedure. While replacing the batteries, be sure not to press any button on the remote control. Doing so may erase the manufacturer code which has been set for other remote control selector buttons.

To reset the manufacturer code to the factory-set code

Follow steps 1 to 2 for the procedure “Setting the manufacturer code”, and enter the device code for the component and “99” while pressing CODE SET in step 2. (It is not necessary to follow step 3.)

(U.S.A. model)

1 While pressing CODE SET, press the input selector button (TV, VCR, DVD/CD) for which the manufacturer code is to be set.

Only one manufacturer code can be set for each input selector button.

Note

•Keep pressing CODE SET between step 1 and 2.

•Refer to “LIST OF MANUFACTURER’S CODES” at the end of this manual.

32