ADJUSTING SPEAKER OUTPUT LEVELS
This section explains how to adjust speaker output levels using the test tone generator. When this adjustment is complete, the output level heard at the listening position should be the same from each speaker. This is important for best performance of the digital sound field processor, and the various decoders (Dolby Digital, Dolby Pro Logic, Dolby Pro Logic II and DTS).
Note
•Since this system cannot enter the test mode while headphones are connected to this system, be sure to unplug the headphones from the PHONES ( SILENT) jack when using the test tone.
LEFT | RIGHT |
CENTER | |
SUBWOOFER |
|
L SUR. | R SUR. |
Using the test tone
Use the test tone to balance the output levels of the speakers.
Note
•The adjustment of each speaker output level should be made at your listening position using the remote control.
|
|
|
|
|
| DVD |
|
|
| CODE SET |
| AMP | AMP | ||
| HALL |
| JAZZ |
| ROCK | ENTERTAINMENT |
|
| 1 |
| 2 |
| 3 | 4 |
|
| SPORTS | MONO MOVIE | MOVIE 1 | MOVIE 2 |
| ||
| 5 |
| 6 |
| 7 | 8 |
|
| /DTS | SELECT | MATRIX 6.1 | STEREO |
| ||
| 9 |
| 0 |
| 10 | CANCEL |
|
| TOP MENU | MENU |
|
| |||
| LEVEL | SET MENU | MUTE |
| |||
|
|
|
|
|
|
| |
j, i |
|
| PRESET |
| ABCDE |
| |
| CH |
| ENTER | CH |
|
| |
TEST |
|
| PRESET |
|
|
| VOL + / — |
ON SCREEN | RETURN | VOL |
| ||||
| TEST |
| B.BOOST |
|
| ||
(U.S.A. model)
1 Press AMP.
2 Press TEST to output the test tone.
3 Press VOL +/– to adjust the volume of this system so you can hear the test tone.
The test tone is heard (in order) from the LEFT (front left speaker), CENTER (center speaker), RIGHT (front right speaker), R SUR. (rear right speaker), L SUR. (rear left speaker), and the SUBWOOFER (subwoofer). The tone is produced for about 2 seconds from each speaker.
4 Adjust the level of the effect speakers using j/ i so that it matches the level of the front speakers.
While adjusting, the test tone is heard from the selected speaker. After j or i is released, the test tone begins travelling to another speaker again.
Note
•To adjust the level of the front speakers, use VOL +/– on the remote control.
5 When adjustment is complete, press TEST to stop the test tone.
y
•It is not necessary to readjust the speaker levels once they are set (as long as you do not change the speakers). You can enjoy listening to or watching the input source at the desired volume simply by pressing VOL +/– on the remote control.
•If the output level of the effect speakers (center, rear left, and rear right) cannot be increased enough to match the level of the front speakers, set “1E F. Level” on SET MENU to
Notes
•If “1A CENTER” on the SET MENU is set to NON, the level of the center speaker cannot be adjusted. The test tone skips the center speaker.
•If “1C REAR LR” on the SET MENU is set to NON, the output level of the rear left and right speakers cannot be adjusted in step 4. The test tone will be circulated skipping the rear right and left speakers.
•If “1D BASS” on the SET MENU is set to FRONT, the test tone will be circulated skipping the subwoofer.
18
