REMOTE CONTROL TRANSMITTER

Loading the batteries for the remote control transmitter

(See figure 6 on page 7.)
1 Remove the battery compartment cover.

(Press the left edge of the cover to right with a finger, and then pull it upward.)

2 Insert 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or equivalent) into the battery compartment.

* Installing the batteries improperly may cause failure.
3 Replace the battery compartment cover.
Precautions for battery use

•Insert the batteries according to the direction indicated in the battery compartment.

•Replace all batteries with new ones at the same time.

•Remove the batteries if they are weak or if the unit is not in use for long periods.

•Don’t mix normal batteries with rechargeable batteries.
REMOVING THE FRONT GRILLE
(See figure 8 on page 8.)

The front grille is fastened to the enclosure at four points, and can be removed if desired. To remove the grille, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the speaker with the four corresponding holes on the inside surface of the grille and push gently.

Proper use of the remote control transmitter

(See figure 7 on page 7.)

Aim (within the range of 60° with no obstacles) the remote control transmitter at the remote control sensor and operate as shown.

Notes concerning use

•Replace the batteries if control distance decreases or operation becomes unstable.

•Periodically clean the transmitter window on the remote control transmitter and the sensor on the main unit with a soft cloth.

•Exposing the sensor on the main unit to strong light (especially an inverter type of fluorescent lamp etc.) may interfere with operation. In this case, reposition the main unit to avoid direct lighting.

•Keep the remote control transmitter away from moisture, excessive heat, shock and vibrations.

•The remote control transmitter’s usable range is within 0.2m (8”) and 6m (20’) away from the sensor.

Note

When the grille is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools.

LISTENING WITH HEADPHONES
(See figure 9 on page 8.)

•Be sure that your headphones have a 3.5 mm (1/8”) diameter plug and are between 16 ohms and 50 ohms impedance. Recommended impedance is 32 ohms.

OPEN/CLOSE THE CONTROL DOOR

•When headphones are connected, the speakers are defeated automatically. Adjust the VOLUME control for desired volume.

When it is not necessary to operate controls inside the control door, close the door.

To open or close the door, press the right edge until it clicks.

E-6