Yamaha CC-75 English, RECORDING COMPACT DISCS, To record programmed tracks from one or more discs, disc, Side of, Selected, the tape, “PROGRAM” and, Next playback order

RECORDING COMPACT DISCS

Receiver

CD Player

TIME 9

1	2	3	4	5
1	2	3	4	5

	6	7	8			5
	6	7	8
	6	7	8	9	0
TIME	A	B	C	D	E
TIME	TIME	PROG	TAPE	EDIT	+10
3	REPEAT	RANDOM	STOP	PLAY/PAUSE OPEN/CLOSE		1
3	MODE	DISC SKIP			TUNER	1
7		PLAY	STOP	PLAY
					TAPE
	DECK					9
	A/B		REC/PAUSE		INPUT	9
4	EFFECT LEVEL		SP/PHONES MODE		DSS

Display information during programming

Selected	Side of
	the tape	Next playback order
disc

PROGRAM

1 2 3 4 5 6 7 8 9 10

A 11 12

Total remaining time onSelected trackthe side of the tape number

REMAIN

PROGRAM

1 2 3 4 5 6 7 8 9 10

A 11 12

Programmed track numbers light up and unprogrammed ones flash.

To record programmed tracks from one or more discs

1 Select the CD position with the INPUT SELECTOR control, watching the display, and load a disc (or discs) on the disc table.

2 Follow steps 3–6 on page 33.3 Press the PROG button.

*“PROGRAM” and “P-01” light up on the display, and all track numbers on the selected disc begin flashing.

4 If necessary, select a desired disc by pressing the DISC SKIP button.5 Select the desired track number by pressing the track number input buttons.

6 Repeat steps 4 and 5 to program more selections for the side A of the tape. You can select the same track again.

*Pressing the TIME button displays the total remaining time on the side of the tape for about 1 second, and then it is replaced by the display of the next playback order.

*If “ERR” appears on the display, the track number just selected cannot be programmed because there is not enough time remaining on the side A of the tape. However, at this time, if any other track number is flashing continuously on the display, you can program it instead of the unprogrammable one.

7 After you finish the programming for the side A, press the TAPE button.*“Pu” appears on the display, then you can begin programming for side B.

8 Repeat steps 4 and 5 to program selections for the side B of the tape. You can select the same track again.

*If “ERR” appears on the display, the track number just selected cannot be programmed because there is not enough time remaining on the side B of the tape. However, at this time, if any other track number is flashing continuously on the display, you can program it instead of the unprogrammable one.

9 Press the EDIT button. (“EDIT” appears on the display.) The recording automatically starts.

Notes on tape-editing

•If programs are made selecting tracks from more than one disc, during recording, the PLAYXCHANGE button on the CD player is disabled.

•To check, cancel or correct program data, refer to page•The maximum number of tracks that can be programmed is 20.•This function can be used to program up to track number

20.If the disc has more than 20 tracks, track number 20 and thereafter will not be programmed.

English

E-35