Press the DISPLAY button to display the current time.

RECEIVING RDS STATIONS <U.K. and Europe models only>

3, 6

4

Receiver

2

1

5

1

2

PTY SEEK

MODE

3

Other functions which make use of RDS data service

This unit has the following functions which make use of RDS data service. These are originally in operation [ON]. However, you can cancel these functions [OFF], if so desired.

➀ON (OFF) CT > CLOCK

This unit corrects the time of the built-in clock automatically by synchronizing it with the CT data on the RDS station being received.

*If you receive an RDS station of some other country, the built-in clock is synchronized with the time setting of the country.

*If the built-in clock is not yet set for current time or reset due to a power failure etc., it will be set for the time of the CT data automatically, whether this setting is ON or OFF.

➁ON (OFF) LOCAL > CT

If the RDS station being received employs the local time (summer time etc.) data service, its time is displayed in the CT mode.

*If the setting of function ➀ is “ON”, the built-in clock is synchronized with the local time data.

➂ON (OFF) A. M. > RDS

Only RDS stations are programmed onto the area for FM stations by the automatic preset tuning operation when the setting is ON.

(See page 21 for the operating procedure.)

If you switch this function OFF, not only RDS stations but also other FM stations are programmed along with MW and LW stations by the automatic preset tuning operation.

To switch these functions on and off

1 Select the FM band by pressing the BAND button, watching the display.

2

3 Press the RDS MODE selector button.

The title of function ➀ “ON CT> CLOCK ” is displayed.

4 Select the title of function whose setting you want to switch by pressing the PTY SEEK MODE button once or more.

5 Switch the function ON or OFF by pressing the PTY SEEK START button, watching the display.

6 Press the RDS MODE selector button again to restore the frequency display mode.

*If the station has PS data, after that, it turns into the PS mode.

Notes

•Once the setting is changed, it will be stored until it is changed again by the above operation.

•During the operation, if there is no operation for about 20 seconds, this mode is canceled and turns into the frequency display.

If the station has PS data, after that, it turns into the PS mode.

English

E-25