Manuals / Brands / Home Audio / Speaker System / Yamaha / Home Audio / Speaker System

Yamaha CC-75 CD synchronized recording, RECORDING COMPACT DISCS, 5 Press the REC/PAUSE button, 4 Set the reverse MODE switch as desired

1 54

Download 54 pages, 933.68 Kb

RECORDING COMPACT DISCS

Receiver

1

6 6

CD Player

Tape Deck

2

4

5

3

2

CD

	1	2	3	4	5
	1	2	3	4	5
	6	7	8			6
	6	7	8	9	0
	A	B	C	D	E
	TIME	PROG	TAPE	EDIT	+10
	REPEAT	RANDOM	STOP	PLAY/PAUSE OPEN/CLOSE
	MODE	DISC SKIP			TUNER
5		PLAY	STOP	PLAY
					TAPE
	DECK					1
	A/B		REC/PAUSE		INPUT
	EFFECT LEVEL		SP/PHONES MODE		DSS
	-	+
	POWER	SLEEP	DISPLAY	VOLUME
				-	+

•When recording important selections, be sure to make a preliminary test to ensure that the desired source material is being properly recorded with good sound quality.

•The automatic recording level control circuit automatically controls the level of the input signal used for recording.

•Adjusting the VOLUME, BALANCE, TREBLE and BASScontrols have no effect on the recorded sound. <Except U.K. and Europe models>If, however, the DSS is on, DSS effect is recorded along with the source.*Music with DSS effect is suitable for listening to inside a car etc.

•The deck which can be used for recording is the DECK B only. When recording, be sure to load a tape into the DECK B cassette compartment.

CD synchronized recording

1 Select the CD position with the INPUT SELECTOR control, watching the display, and load the disc to be recorded.

2 Load a tape into the DECK B cassette compartment.

*Wind past the beginning part of the tape on which recording cannot be performed.

3 When recording with the Dolby NR system, set the Dolby NR switch to B or C; if not, set it to OFF.

*For selection of the Dolby B or C position, refer to the “Dolby B and C Type Noise Reduction” on page 29.

4 Set the reverse MODE switch as desired.

When the tape is set so that side A faces you, recording will be done as follows automatically according to the selected reverse mode.

Side A only	Side A → Side	Side A → Side
	B	B
Side B only	Side B only	Side B only

5 Press the REC/PAUSE button.*The corresponding indicator lights up and the play direction indicators flash.

6 Start CD playback by pressing the corresponding disc selector button, or by pressing the play/pause / button if the disc is already selected.

*Before CD playback begins, recording automatically begins on the side of the tape now selected.

E-30

Contents

Page ●After unpacking, check that the following parts are contained ●Après le déballage, vérifier que les pièces suivantes sont incluses ●Nach dem Auspacken überprüfen, ob die folgenden Teile vorhanden sind ●Kontrollera efter det apparaten packats upp att följande delar finns med ●Controleer na het uitpakken of de volgende onderdelen voorhanden zijn 1CDC-S75 2RX-S75 EFG H WX Y H 3KXW-S75 cd e f g h ij 4 NX-S75 HIJK L To AC outlet Vers la prise c.a Zur Netzsteckdose Till nätuttag Alla presa AC INTRODUCTION English FEATURES •75W + 75W (6Ω) Output Power, 10% THD, 1 kHz •Random Access Programmable CD Playback PRECAUTIONS: READ THIS BEFORE OPERATING YOUR UNIT ■Do not operate this unit upside-down.It may overheat, possibly causing damage ■Never open the cabinet. If something drops into the set, contact your dealer Condensation can cause the unit to malfunction. To eliminate condensation: •CD pickup SETTING UP THE SYSTEM Setup examples KXW-S75 RX-S75 CDC-S75 (See figure 1 and 2 on page 3 – 5 at the beginning part of this manual.) 1Disc Table 2Stop Button: 3Disc Selector Buttons 4TIME Button Names of control buttons (See figure 5 on page 7 at the beginning part of this manual.) 1Remote Control Transmitter Window 2Preset Station Number Buttons 3A, B, C, D, E Selector Buttons Loading the batteries for the remote control transmitter (See figure 6 on page 7.) (See figure 8 on page 8.) Proper use of the remote control transmitter (See figure 7 on page 7.) Antenna connection Speaker connection System connection (See figure 0 on page 8.) Connecting the AC supply lead (See figure A on page 8.) SETTING THE CLOCK Changes Minute Second 2 While pressing the TIME ADJ button, press the HOUR button and set the hour The hour setting will not advance even if minute is advanced from “59” to “00” Volume Balance Tone Listening to the music with the DSS Care of compact discs CD playback Direct-selectionplay Skip search Manual search Program play To stop program play •Press the stop button. The first programmed track number will be displayed To resume playback, press the play/pause To cancel a programmed sequence There are several methods as described below Repeat play Random play Switching the time display Automatic tuning Manual tuning Preset tuning Automatic preset tuning Displaying RDS data To turn the unit into the RDS mode Calling a preset RDS station by the program type (PTY SEEK) Other functions which make use of RDS data service General information Tape A or tape B playback Winding the tape Searching for the beginning of a desired selection Continuous playback CD synchronized recording To stop recording temporarily 1 Press the stop button of the CD player 2 Choose the selection to be recorded next by using the control transmitter) To stop recording Recording CD(s) on both sides of a tape automatically Automatic tape-editing Page To record programmed tracks from one or more discs 2 Follow steps 3–6on page 3 Press the PROG button 4 If necessary, select a desired disc by pressing the DISC SKIP button 5 Select the desired track number by pressing the track number input buttons Recording from the built-intuner Dubbing Erasing recorded tapes Timer play ➂ At ON TIME/time setting mode TIME ADJ TIMER HOUR MINUTE ➃At OFF TIME/time setting mode To cancel the timer play setting Timer recording (To record a tuner program) Sleep timer operation Using the timer and the sleep timer at the same time <U.S.A., Canada, Australia, Singapore and General models <U.K. and Europe models Internal care External care TROUBLESHOOTING SPECIFICATIONS