4
Voice Controls and Effects
DDK-7 Owner’s Manual
58
PITCH CHANGE

This effect changes the pitch.

MISCELLANEOUS

Creates special effects.

AMBIENCE
IMPULSE EXP
RESONATOR
VOICE CANCEL
TALKING MOD
LO-FI
DYNA FILTER
Effect Type
PITCH CHANGE
XG PCH CHG 1
XG PCH CHG 2
Parameter Value Description
Pitch -24 - +24 Determines the amount of
pitch change in semitones.
Pitch Fine 1 -50 - +50 Fine pitch adjustment to
detune the sound and create
a chorus effect.
Pitch Fine 2 -50 - +50 Fine pitch adjustment to
detune the sound and create
a chorus effect.
Initial Delay 0.1 - 400 msec Determines the time that
elapses between the original
sound and the early
reflections.
Feedback
Level
-63 - +63 Determines the amount of
delayed repeats in the
sound. When this is set to
0%, the delayed repeat from
the second time will not
sound.
Dry/Wet D63>W - D<W63 Determines the balance of
original sound and the effect
sound.
Effect Type
AMBIENCE
IMPULSE EXP
RESONATOR
VOICE CANCEL
TALKING MOD
LO-FI
DYNA FILTER
DYNA RINGMOD
RING MOD
ISOLATOR
Parameter Value Description
DelayTime 0.0 - 50.0 msec Determines the delay time.
Output Phase Normal, Invers Determines the phase of the
effect sound.
Dry/Wet D63>W - D<W63 Determines the balance of
original sound and the effect
sound.
Parameter Value Description
Density 0.159 - 22.61 msec Determines the density.
Dispersion 4.028 msec - 4.000
sec
Determines the resonance
time.
Wet Level 0 - 127 Determines the level of the
effected sound.
Parameter Value Description
Type Type1 - 6 Determines the type.
Decay Time 4.028 msec -
4.000 sec
Determines the length of
reverberation.
LPF Cutoff 28.5Hz -
21.6 kHz (Thru)
Determines the cutoff
frequency of the Low Pass
Filter. The portion of the
signal above the specified
frequency is cut.
Dispersion 0 - 16 Determines the resonance
time.
Wet Level 0 - 127 Determines the level of the
effected sound.
Parameter Value Description
Low Adjust 0 - 26 Determines the frequencies
in the lower portion of the
middle range that are
attenuated.
High Adjust 0 - 26 Deter mines the frequencies
in the upper portion of the
middle range that are
attenuated.
Parameter Value Description
Vowel a, i, u, e, o Determines the specific
vowel used for the “talking”
effect.
Drive 0 - 127 Determines the effect depth.
OutputLevel 0 - 127 Determines the output level
of the effect-processed
sound.
Parameter Value Description
Sampling
Control
44.1 kHz - 345.0 Hz Determines the sampling
frequency.
Word Length 0 - 127 Determines the resolution or
roughness of the sound.
Filter Type Thru, PwrBass,
Radio, Tel, Clean,
Low
Determines the filter type.
Dry/Wet D63>W - D<W63 Determines the balance of
original sound and the effect
sound.
Parameter Value Description
Sensitivity 0 - 127 Deter mines the sensitivity.
The higher the value the
greater the change.