13
Projection
6

◆Turning the power on

Always remove the lens cap before operating the main unit.

Turning the projector power on

1. Insert the supplied power cable

firmly into the AC inlet at the rear

of the main unit, then insert the

plug into an AC outlet.

The STANDBY/ON indicator lights orange.

2. Press the STANDBY/ON button

(the button on the remote

control).

The indicator blinks green and the lamp

lights up in preparation for projection. After

approximately 35 seconds, the indicator

changes from blinking to solid green,

indicating that the unit is ready to project.

Warning
• Do not remove the power cable while the STANDBY/ON indicator is blinking green or
lit steady green. This could damage the lamp or reduce lamp life.
HDMI
G/Y B/P
B
/C
B
R/P
R
/C
R
INPUT A
HD/SYNC VD
OUT IN
REMOTE TRIGGER OUT
S-VIDEO VIDEO
INPUT B
RGB/YP
B
P
R
/YC
B
C
R
RS-232C
D4 VIDEO
STANDBY/ONSETTINGLAMP COVER TEMP FANPATTERNESCAPE MENUINPUTASPECT
STANDBY/ON
indicator
AC inlet
INPUTMENUPATTIRISAUTOSETTINGASPECTZOOM FOCUSV. POSESCAPE
STANDBY/ONSETTINGLAMP COVER TEMP FANPATTERNESCAPE MENUINPUTASPECT
Remote Control Main unit
button STANDBY/ON button
12_DPX-1100_E.p65 11/26/04, 1:47 PM13