1Audio Signal Connection Jacks (for Audio Source Equipment) Connect the inputs and/or outputs of your audio equipment.

2Audio/Video Signal Connection Jacks (for Video Source Equipment)

Connect the audio and video inputs and/or outputs of your video equipment. In place of the VIDEO jacks, the S VIDEO jacks can be used for higher resolution and improved picture quality if your VCR, monitor, etc. are equipped with S-VIDEO connectors.

3Main Level Switch

Normally set to “0 dB”. If desired, you can decrease the main- channel output level at the MAIN speaker terminals by 10 dB by setting this switch to “–10 dB”.

4Pre Out Jacks

Main-channel line output. Connected with jumper bars to MAIN IN jacks when the built-in amplifier is used. Connected to input jacks of external stereo power amplifier (MAIN IN or TAPE PLAY jacks of integrated amplifier or receiver) when using external amplification.

5Main In Jacks

Line input to built-in main-channel amplifier. Connected with jumper bars to PRE OUT jacks when the built-in amplifier is used. Not connected when using an external power amplifier.

6Main Speaker Terminals

When using this unit’s built-in main-channel amplifier, connect the main speakers here. The jumper bars must be plugged in to connect the MAIN IN jacks to the PRE OUT jacks.

7Front Effect Speaker Terminals

When using the built-in front-channel amplifier, connect the front effect speakers here.

8Center Speaker Terminals

When using the built-in center-channel amplifier, connect one or two center speakers here.

9Center Speaker Impedance Switch

Set to “A + B” when using two center speakers, or to “A OR B” when using only one center speaker.

0Rear Effect Speaker Terminals

When using the built-in rear-channel amplifier, connect the rear effect speakers here.

AGND Terminal

Connects the ground wire of the turntable to produce minimum hum. In some cases, however, better results may be obtained with the ground wire disconnected.

BVideo NTSC/PAL Switch (General Model only)

Set this switch to the position corresponding to the standard that your video equipment employs.

CFront Effect Out Jacks

Front-channel line output. Not connected when the built-in amplifier is used. Can be connected to input jacks of an external stereo power amplifier driving the front effect speakers.

DFront Mix Switch

Set to “OFF (7ch)” when setting up a full 7 or 6 speaker system, or to “ON (5ch)” when setting up a 5 or 4 speaker system.

ERear Effect Out Jacks

Rear-channel line output. Not connected when the built-in amplifier is used. Can be connected to input jacks of an external stereo power amplifier driving the rear effect speakers.

English

11