6Remote Control Sensor

Signals from the remote control unit are received here.

7Input Source Indicators

Shows the currently selected input source by lights up the corresponding indicator.

8Input Selector Switch

Sequentially selects the input source that you want to listen to and/or watch in the ß or © direction. The indicator corresponding to the selected input source lights up. The selected input source is also shown by the display panel and the monitor screen (When the monitor is on).

9Input Selector Switches for VCR 1, CD and LD Directly selects VCR 1, CD or LD as the input source.

0Phones Jack

Plug in headphones here for private listening. If the FRONT MIX and EFFECT switches are on, the effect channels will be heard along with the main channels. Otherwise the main channels only will be heard.

ARec Out Switch

Used to select the source to be recorded to tape deck or VCR independent of the selection of input source. When pressed, the indicator corresponding to the currently selected source to be recorded flashes. While an indicator is flashing, you can change the selection of the source to be recorded with the input selector switches. The selected source is also shown by the display panel and the monitor screen (when the monitor is on).

BInput Trim Control

Adjusts the input level of each source respectively.

CProgram Selector

Sequentially selects the digital sound field processing programs in the + or – direction.

DEffect Switch

Normally ON, this switch can be turned OFF to disable output from the center and effect speakers so that the sound becomes normal 2-channel stereo.

EBass and Treble Controls

Adjust the sound to match your tastes. Can also be used to compensate for room acoustics. Defeated in the center position.

FBalance Control

Adjusts the left and right output volume to the Main Speakers to compensate for sound imbalance caused by speaker positions or listening room conditions.

GAuxiliary Input Jacks (AUX 2)

Connect an auxiliary video or audio input source equipment such as a camcorder to these jacks. If the connected video equipment has a S video output terminal, connect it to the S VIDEO jack to obtain a high resolution picture. The source connected to these jacks can be selected by the input selector switch.

HMaster Volume Control

Simultaneously controls signal level at all outputs: front effect, main, rear effect, center, and subwoofer. (This does not affect TAPE REC OUT level.)

English

21