2.Adjusting Center Channel Graphic Equalizer (CENTER GEQ)

The built-in five band graphic equalizer is used to tailor, over a ±6 dB range, the overall output frequency response of the center channel. The five bands cover the complete audible sound spectrum and are centered on 100 Hz, 300 Hz, 1 kHz, 3 kHz and 10 kHz frequencies. Adjustment should be done to each frequency individually.

Adjusting method

After selecting the item (title) in step 2 on the previous page, press the Parameter + or – key on the remote control to display the condition of the equalizer. Then select a frequency with the Parameter Select keys on the remote control and adjust its level with the Parameter +/– keys.

4.Locking DSP parameters and other adjustments(MEMORY GUARD)

If you wish to prevent accidental alteration to DSP parameters or other adjustments on this unit, select “ON”. In this position, they are locked and cannot be changed. The following functions on this unit can be locked by this operation.

•DSP parameters

•Other items in the “SET MENU” mode

(CENTER MODE/CENTER GEQ/PARAMETER INIT/INPUT LVL TRIM)

•ON SCREEN display key

•INPUT TRIM control

•FRONT, REAR and CENTER level +/– keys

•TEST switch

English

3.Initializing parameters on a DSP program (PARAMETER INIT)

You can initialize all parameter settings on a DSP program. Note that a DSP program (except CHURCH) has two sub- programs; all parameters on both sub-programs are initialized by this operation.

Initializing method

After selecting this item (title) in step 2 on page 26, press the Parameter + or – key to display the DSP program numbers (1 – 12). A program number whose parameters has been changed is

marked with “”. Press a Program Select Key corresponding to the

*

program number of which parameters you want to initialize. When

initialized, the “” mark will disappear.

*

5. Input level adjustment (INPUT LVL TRIM)

This function is provided for all input sources. It can be controlled from 0 to +6 dB in 2 dB steps. The sound level of each input source should be the same as that of regular CDs.

To adjust the input level, either press the INPUT TRIM control on the front panel (see page 25), or select the “5. INPUT LVL TRIM” in step 2 on page 26.

27