Remote Control Features
Programming a New Remote Control Function
If you desire to program functions not included in the basic operations covered by the manufacturer code, or a manufacturer code is not available, the following procedure needs to be performed. The possible programming area is the same as a component control area, so buttons are programmable independently for each source component area. It is also possible to program in the main unit control area. (Refer to page 50 for details on component control area and main unit control area.)
| 1 VCR | SYSTEM POWER | TRANSMIT | |
TITLE | 3 VCR 2 VCR | TUNER CBL/SAT | LEARN CLEAR | |
% | LD | MD | TAPE | MACRO |
INPUT 6CH | DVD | CD | PHONO | MACRO ON OFF |
1Place this remote control and the other remote control about 5 to 10 cm (2 to 4 in.) apart on a flat surface so that their infrared transmitters are aimed at each other.
2Select a source component.
5~10 cm (2 to 4 in.)
LEARN
3Press LEARN using a ball point pen or similar object.
flashes alternately
Advanced Operation
| 1 VCR | SYSTEM POWER | TRANSMIT |
| |
TITLE | 3 VCR 2 VCR | TUNER CBL/SAT | LEARN CLEAR |
| |
% | LD | MD | TAPE | MACRO |
|
INPUT 6CH | DVD | CD | PHONO | ON OFF | MACRO |
| 1 VCR | SYSTEM POWER | TRANSMIT |
| |
TITLE | 3 VCR 2 VCR | TUNER CBL/SAT | A/B | LEARN CLEAR |
|
% | LD | MD | TAPE TAPE | MACRO |
|
INPUT 6CH | DVD | CD | PHONO | ON OFF | MACRO |
LEARN
4Press and release the button where you want the new function to be programmed.
5Press and hold the button on the other remote control that has the function you want to program into this remote control until “OK” appears in the display window.
•“NG” appears in display window when programming is not done correctly.
6Repeat Steps 4 and 5 to program additional functions.
7Press LEARN again to exit the Learn mode.
Notes:
•If you do not press any button within 30 seconds, the learning process is canceled.
•This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of the other remote control’s functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for the other remote control.) When the memory is full, “FULL” appears in the display window, and this remote control cannot acquir e any more functions. Clear unnecessary programmed functions to allow the unit to acquire new functions.
•Even if the batteries in the other remote control have enough power to transmit signals for operation, they may not have enough power to transmit signals to this remote control.
•When the remote controls are either too close together or too far apart, you may not be able to program this remote control.
•Direct sunlight interferes with infrared rays.
•“ERROR” appears in the display window in the following conditions: when pressing more than one button at once; and when MACRO ON/OFF is switched to another position.
58