Troubleshooting
Problem | Possible Cause | What to Do |
A source cannot be recorded | The source unit is connected to this unit | Make additional connections to the analog |
by a tape deck or VCR | using digital jacks only. | jacks (see pages 16 through 19). |
connected to this unit. |
|
|
|
|
|
“CHECK SP WIRES!" appears | Speaker cables are short circuited. | Make sure all speaker cables are |
on the display. |
| connected correctly. |
|
|
|
There is noise from a nearby | This unit is too close to the affected | Move this unit farther away from the affected |
TV or tuner. | equipment. | equipment. |
|
|
|
The sound is degraded when | The power to this unit is off. | Turn on the power to this unit. |
listening with the headphones |
|
|
connected to the CD player or |
|
|
cassette deck that are |
|
|
connected to this unit. |
|
|
|
|
|
“INPUT DATA ERROR” | A | Check the source, or turn off the source |
appears on the display and no | the equipment playing back the source is | equipment, then turn it on again. |
sound is heard. | not operating correctly. |
|
|
|
|
Problem | Possible Cause | What to Do | |
The remote control does not | The batteries are dead. | Replace the batteries with new ones and | |
work. |
| press RESET (see page 5). | |
|
|
|
|
|
| The internal microcomputer has “frozen”. | Press RESET on the remote control (see |
|
|
| page 5). |
|
|
|
|
The remote control does not | Wrong distance or angle. | The remote control will function within a | |
function properly. |
| maximum range of 6 m (20 feet), no more | |
|
|
| than 30 degrees |
|
|
| (see page 5). |
|
|
|
|
|
| Direct sunlight or lighting (such as an | Change the position of this unit. |
|
| inverter type of fluorescent lamp) is striking |
|
|
| the remote control sensor of this unit. |
|
|
|
|
|
|
| The internal microcomputer has “frozen”. | Press RESET on the remote control (see |
|
|
| page 5). |
|
|
|
|
The remote control | The batteries of this remote control and/or | Replace the batteries (and press RESET on | |
does not “learn” new functions. | the other remote control are too weak. | the remote control) (see page 5). | |
(The TRANSMIT indicator does |
|
| |
|
| ||
not light up or flash.) | The distance between the two remote | Place the remote controls at the proper | |
|
| controls is too far or near. | distance (see page 58). |
|
|
|
|
|
| The signal coding or modulation of the | Learning is not possible. |
|
| other remote control is not compatible with |
|
|
| this remote control. |
|
|
|
|
|
|
| Memory capacity is full. | Further learning is not possible without deleting |
|
|
| unnecessary new functions (see page 62). |
|
|
|
|
|
| The internal microcomputer has “frozen”. | Press RESET on the remote control (see |
|
|
| page 5). |
|
|
|
|
Continuous functions such as | The learning process is incomplete. | Be sure to press and hold the function button | |
volume are learned, but |
| on the other remote control until TRANSMIT | |
operate only for a moment |
| begins flashing slowly. | |
before stopping. |
|
| |
|
|
|
|
English
81