Yamaha DSP-AZ2 ■Operating the macro, ■Programming a macro

REMOTE CONTROL FEATURES

■Operating the macro

					MACRO
				MACRO	MACRO ON/OFF
TRANSMIT RE-NAME CLEAR LEARN MACRO				OFF ON
SYSTEM	STANDBY	A	B	PHONO
POWER
V-AUX	TUNER	MD/TAPE	CD-R	CD
D-TV/LD CBL/SAT		VCR 1	VCR2/DVR	DVD	Macro buttons

1 Set MACRO ON/OFF to ON.

2 Press a macro button.

Notes

•When you have finished using the Macro feature, set MACRO ON/OFF to OFF.

•While this unit is carrying out a macro program, this unit does not receive any other button’s function until the macro operation has been completed (the TRANSMIT indicator stops flashing).

•Continue to aim the remote control at the component the macro is operating until the macro operation has been completed.

■Programming a macro

You can program your own macros and use the Macro feature to transmit many remote control commands by pressing a single button.

Notes

•The factory-set macro is not cleared when a new macro is programmed for a button. The factory-set macro can be used again when the programmed macro is cleared.

•It is not possible to add a new signal (macro step) to the factory-set macro. Programming a macro changes all macro contents.

•A macro programming is used to transmit learning or setup (or YAMAHA preset) button signals of this remote control to a macro button. If necessary, set up the manufacturer code or program a function with the remote control for your component.

•This remote control handles button signals that operate continuously, such as volume control, as short time interval codes. Macro programming that include these types of macro steps are therefore not recommended.

1 Press MACRO by using a ballpoint pen or similar object.

“MCR ?” appears in the display window.

MACRO

Note

•Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press MACRO again.

2 Press a macro button for which you want to program the macro operation.

The button you chose for programming the macro operation and the selected component name appear alternately in the display window.

SYSTEM	STANDBY	A	B	PHONO
POWER
V-AUX	TUNER	MD/TAPE	CD-R	CD
D-TV/LD	CBL/SAT	VCR 1	VCR2/DVR	DVD

Note

•“AGAIN” appears in the display window when a button other than the macro buttons is pressed.

3 Press the buttons of the functions that you want to include in the macro operation sequence in order.

y

•You can set up to 10 steps (10 functions). After you have set 10 steps, “FULL” appears and the remote control automatically exits from the macro mode.

SYSTEM	STANDBY	A	B	PHONO
POWER
V-AUX	TUNER	MD/TAPE	CD-R	CD
D-TV/LD	CBL/SAT	VCR 1	VCR2/DVR	DVD

				6CH INPUT
		TITLE
			ENTER
SOURCE
	DISPLAY	MENU		SOUND
SELECT	SEARCH		– CHAPTER +
POWER	REC	STOP	PAUSE	PLAY 1

2 MCR 1	: DVD a
MCR 2	: DVD p

indicate the number of macro steps you entered

appear alternately so that you can set up the next step

Notes

•“NG” appears in the display window when programming has not been done correctly. In this case, start over from step 2.

•If you want to change the source component, use SOURCE SELECT k/ n. When you use the input selector buttons, selecting the input is programmed as a macro step, whereas SOURCE SELECT k/ nonly changes the component.

46