To listen to a decoded source using Dolby Digital (AC-3) by reproducing the signals input to the 6CH DISCRETE INPUT terminals of this unit.

In step 3, select TV/DBS or DVD/LD, and then press the 2CH/6CH button so that “6ch” appears on the display. Signals from the Dolby Digital (AC-3) Decoder etc. connected to the 6CH DISCRETE INPUT terminals of this unit are selected as the input signals.

2CH/6CH

To cancel it, press the 2CH/6CH button again or select another input source.

Note for reproducing discrete signals with Dolby Digital (AC-3) decoded:

1.Your speaker system must include a center speaker.

2.Your speaker system must include a subwoofer.

*Connect a subwoofer which has a built-in amplifier to one of the SUBWOOFER OUTPUT terminals of this unit. (One more subwoofer system can be connected to the other SUBWOOFER OUTPUT terminal.)

*You can do without using a subwoofer. If you do so, you should make a setting for distributing signals at the LFE channel to the right and left MAIN output terminals on the Dolby Digital (AC-3) Decoder.

For details, refer to the owner’s manual for the Dolby Digital (AC-3) Decoder.

Notes

●When you switch to the “6CH” mode, the built-in Digital Sound Field processor will not work and adjustment of delay time cannot be made.

●Switching this unit to the “6CH” mode will input no signal to this unit if there is no connection to the 6CH DISCRETE INPUT terminals of this unit.

To listen to sound by reproducing signals input to the INPUT (from AMP/RECEIVER PREOUT) terminals on the rear panel from the external amplifier etc.

1.Adjust the volume to minimum on the external amplifier.

2.Turn on the power of the audio/video units (including this unit) to be used.

3.Set the PROCESSOR SELECTOR switch on the front panel of this unit to the “EXTERNAL” position.

PROCESSOR

SELECTOR

INTERNAL

EXTERNAL

4.Play the source.

5.Increase the volume to a desired listening level gradually on the external amplifier etc.

6.If desired, adjust the balance, tone, etc. on the external amplifier etc.

Note

When you will not use signals input to the INPUT (from AMP/RECEIVER PREOUT) terminals on the rear panel, make sure to set the PROCESSOR SELECTOR switch to the “INTERNAL” position.

English

21