Yamaha DSP-E492 CONNECTIONS, REAR PANEL PARTS AND THEIR FUNCTIONS, B C D

CONNECTIONS

REAR PANEL PARTS AND THEIR FUNCTIONS

1 2 3 4 5 6 7

MAIN	CENTER	REAR	MAIN CENTER REAR	MAIN	CENTER	SINGLE:8ΩMIN./SPEAKER
						DUAL:4ΩMIN./SPEAKER
					REAR	8ΩMIN./SPEAKER

			INPUT			CENTER	SINGLE:4ΩMIN./SPEAKER
			from
6CH DISCRETE							DUAL:2ΩMIN./SPEAKER
			AMP/RECEIVER			REAR
							6ΩMIN./SPEAKER
INPUT			PREOUT			IMPEDANCE SELECTOR
	SUB	(SURROUND)			SUB	CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
	WOOFER				WOOFER	(SURROUND)
VIDEO SIGNAL						REAR
		MONITOR		DVD/LD	IN	OUT				SUB
			OUT		TV/DBS	VCR		REAR	CENTER
										WOOFER
AUDIO SIGNAL						CENTER
1	2	3 TAPEPB	OUTREC 4				DUAL	DUAL
					IN	OUT	SINGLE	(SURROUND)	DUAL	l
CD	TUNER	TAPE		DVD/LD	TV/DBS	VCR				DUAL
(LINE 1)	(LINE 2)	( MD )				OUTPUT	SPEAKERS		OUTPUT
		INPUT

8 9 0 A B C D

MAINS

l0dB 0dB	I00W MAX.
MAIN	SWITCHED
LEVEL	AC OUTLET

(Europe model)

16CH DISCRETE INPUT terminals 4IMPEDANCE SELECTOR switch

Connect a Dolby Digital (AC-3) Decoder to these terminals. 6-channels (left main, right main, center, left rear surround, right rear surround and subwoofer) of discrete audio signals with the Dolby Digital (AC-3) decoded are input to these terminals from the decoder.

2INPUT (from AMP/RECEIVER PREOUT) terminals These are additional 6-channel audio signal input terminals (for left main, right main, center, left rear surround, right rear surround and subwoofer channels) available for inputting signals from your existing amplifier, receiver, sound processor, etc. to this unit.

To listen to a sound by reproducing signals input to these terminals from the external amplifier etc., be sure to set the PROCESSOR SELECTOR switch on the front panel to the “EXTERNAL” position. By doing so, the signals input to these terminals are sent to the corresponding SPEAKERS terminals and OUTPUT terminals of this unit bypassing any circuit in this unit. So, volume, tone, etc. must be controlled on the external amplifier.

PROCESSOR

SELECTOR

INTERNAL

EXTERNAL

3MAIN OUTPUT terminals

Main-channel line output. Connect these to input terminals of external stereo power amplifier (MAIN IN or equivalent terminals of integrated amplifier or receiver) driving the main speakers.

Select the position whose requirements your speaker system meets.

Be sure to switch this only when the power of this unit is turned off.

(Right position)

Center: If you use one center speaker, the impedance of the speaker must be 8Ω or higher.

If you use two center speakers, the impedance of each speaker must be 4Ω or higher.

Rear: The impedance of each speaker must be 8Ω or higher.

(Left position)

Center: If you use one center speaker, the impedance of the speaker must be 4Ω or higher.

If you use two center speakers, the impedance of each speaker must be 2Ω or higher.

Rear: The impedance of each speaker must be 6Ω or higher.

WARNING

Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.

8