FEATURES

English

●Center and Rear Channel Power AmplifierCenter: 60W (8Ω ) RMS Output Power,0.04% THD, 20 – 20.000 HzRear: 60W + 60W (8Ω ) RMS OutputPower, 0.04% THD, 20 – 20.000

Hz

●Digital Sound Field Processor●Dolby Pro Logic Surround Decoder

●Theater-like Sound Experience by the Combination of Dolby Pro Logic and YAMAHA DSP Technology (CINEMA DSP)

●Automatic Input Balance Control for Dolby Pro Logic Surround
●Test Tone Generator for Easier Speaker Balance Adjustment●3 Center Channel Modes (NORMAL/WIDE/PHANTOM)●Video Signal Input/Output Capability

●6-Channel Discrete Input Terminals for Connecting with a Dolby Digital (AC-3) Decoder

●6-Channel Input Terminals to Input Audio Signals from Your Existing Amplifier or Receiver

●Remote Control Capability

NOTES ABOUT THE REMOTE CONTROL TRANSMITTER

Battery installation

 

 

 

 

Remote control transmitter operation range

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

1

3

Battery replacement

If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones.

Notes

●Use only AA, R6, UM-3 batteries for replacement.

●Be sure the polarities are correct. (See the illustration inside the battery compartment.)

●Remove the batteries if the remote control transmitter will not be used for an extended period of time.

●If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

Remote control sensor

Within approximately 6 m (19.7 feet)

30

 

°

°

30

 

 

Notes

●There should be no large obstacles between the remote control transmitter and the main unit.

●If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid direct lighting.

5