TROUBLESHOOTING

Problem

Solution

 

 

Sound played on the DVD receiver cannot be

Use proper audio sources.

recorded with an external recorder

 

 

 

Sounds played on the AV equipment connected to

Connect those equipment to the DVD receiver with along connections.

the DVD receiver cannot be recorded with external

 

recording equipment

 

 

 

The volume does not increase or sounds are

Turn on the power of the component connected to the DVD receiver.

distorted

 

 

 

There is no sound from the center, surround

Make sure the center, surround speakers and subwoofer are connected correctly.

speakers and subwoofer

 

Adjust the volume level in the setup menu.

 

 

 

 

Press SURR button to select a correct surround sound setting.

 

 

 

Make sure the source you are playing is recorded or broadcast in surround

 

sound (DTS, Dolby Digital, etc.).

 

 

“SPEAKER ERR” appears in the display panel

Unplug the subwoofer, then make sure the front, center and surround speakers

 

are connected correctly.

 

 

 

Set the DVD receiver to the standby mode, then disconnected the power cord.

 

Wait for about 30 seconds, then reconnect the power cord and turn on the DVD

 

receiver.

 

 

Radio reception is poor

If the signal is too weak, adjust the antenna or connect an external antenna for

 

better reception.

 

 

 

Increase the distance between the receiver and your TV or VCR.

 

 

 

Tune in to the correct frequency.

 

 

 

Place the antenna farther away from any equipment that may be causing the

 

noise.

 

 

The remote control does not function properly

Select the source (DVD/CD or TUNER, for example) before pressing the

 

function button (h, b/ a).

 

 

 

Reduce the distance between the remote control and the receiver.

 

 

 

Replace the batteries with new ones.

 

 

 

Point the remote control directly toward the remote control sensor.

 

 

 

Check that the batteries are loaded correctly.

 

 

The remote control does not work for operating

Set the correct remote control code. Depending on the model and year of the

other equipment

product, the DVD receiver’s remote control may not be able to operate it partly

 

or wholly. In this case, use the remote control supplied with each product.

 

 

Unable to play DivX® movies

Check that the DivX® file was encoded in ‘Home Theater’ mode with a DivX®

 

5.x encoder.

 

 

The DVD receiver does not work

Disconnect the power cord from the power outlet for a few minutes. Reconnect

 

the power cord and try to operate again as usual.

 

 

6

FEATURES OTHER

English

51