E
|
| Tightening torque: | |
|
| Refer to “SPECIFICATIONS” page | |
|
|
| |
|
| 4) Align the propeller nut with the pro- | |
|
| peller shaft hole. Insert a new cotter | |
|
| pin in the hole and bend the cotter pin | |
|
| ends. | |
|
| NOTE: |
|
602053 |
| If the propeller nut does not align with the | |
|
| propeller shaft hole after tightening to the | |
| |||
|
| specified torque, then tighten the nut fur- | |
|
| ther to align it with the hole. | |
|
|
|
|
EMU01460
CHANGING GEAR OILw
8Be sure the outboard is securely fastened to the transom or a stable stand. You could be severely injured if the outboard falls on you.
8Never get under the lower unit while it is tilted, even when the
1)Tilt the outboard motor so that the oil drain plug is at the lowest point possi- ble.
2)Place a suitable container under the