SPEAKER SETUP
Connecting the speakers
Be sure to connect the left channel (L), right channel (R), “+” (red) and
CAUTION
•Use speakers with the specified impedance shown on the rear panel of this unit.
•Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or the speakers.
If necessary, use the SET MENU to change the speaker mode settings according to the number and size of the speakers in your configuration after you finish connecting your speakers.
■Speaker cables
10 mm (3/8”)
1 | 2 |
A speaker cord is actually a pair of insulated cables running side by side. One cable is colored or shaped differently, perhaps with a stripe, groove or ridge.
1 Remove approximately 10 mm (3/8”) of insulation from each of the speaker cables.
2 Twist the exposed wires of the cable together to prevent short circuits.
■Connecting to the SPEAKERS terminals
Red: positive (+) | 2 |
Black: negative | 3 |
|
1
(U.S.A. model)
Banana plug
1 Unscrew the knob.
2 Insert one bare wire into the hole in the side of each terminal.
3 Tighten the knob to secure the wire.
y
(U.S.A., Canada, Australia, China, Korea and General models)
•Banana plug connections are also possible. First, tighten the knob and then insert the banana plug connector into the end of the corresponding terminal.
(U.S.A. model)
■MAIN SPEAKERS terminals
One or two speaker systems can be connected to these terminals. When using only one speaker system, it can be connected to either the MAIN A or the MAIN B terminals.
■REAR SPEAKERS terminals
A rear speaker system can be connected to these terminals.
■CENTER SPEAKER terminals
A center speaker can be connected to these terminals.
■REAR CENTER SPEAKER terminals
A rear center speaker can be connected to these terminals.
10
