SPEAKER SETUP

Speaker placement

The speaker layout below shows the standard ITU-R*speaker setting. You can use it to enjoy CINEMA DSP and multi-channel audio sources.

*ITU-R is the radio communication sector of the ITU (International Telecommunication Union).

PL

 

PR

 

 

C

FL

 

FR

 

 

30˚

SL

 

SR

 

 

60˚

SL

80˚

SR

 

SBL

SBR

30 cm (12 in) or more

Surround speakers (SR and SL)

The surround speakers are used for effect and surround sounds. Place these speakers behind your listening position, facing slightly inwards, about 1.8 m (6 ft) above the floor.

Surround back speakers (SBR and SBL)

The surround back speakers supplement the surround speakers and provide for more realistic front-to-back transitions. Place these speakers directly behind the listening position and at the same height as the surround speakers. They should be positioned at least 30 cm (12 in) apart. Ideally, they should be positioned at the same width as the front speakers.

Subwoofer

The use of a subwoofer, such as the YAMAHA Active Servo Processing Subwoofer System, is effective not only for reinforcing bass frequencies from any or all channels, but also for high fidelity reproduction of the LFE (low- frequency effect) channel included in Dolby Digital and DTS software. The position of the subwoofer is not so critical, because low bass sounds are not highly directional. But it is better to place the subwoofer near the front speakers. Turn it slightly toward the center of the room to reduce wall reflections.

PREPARATION

 

Presence speakers (PR and PL)

 

Presence speakers supplement the sound from the front

 

speakers with extra ambient effects produced by CINEMA

 

DSP (see page 55). These effects include sounds that

1.8 m (6 ft)

filmmakers intend to locate a little farther back behind the

1.8 m (6 ft)

screen in order to create more theater-like ambience. Place

 

these speakers at the front of the room about 0.5 - 1 m

 

(1 - 3 ft) outside the front speakers, facing slightly

 

inwards, and about 1.8 m (6 ft) above the floor.

Front speakers (FR and FL)

The front speakers are used for the main source sound plus effect sounds. Place these speakers an equal distance from the ideal listening position. The distance of each speaker from each side of the video monitor should be the same.

Center speaker (C)

The center speaker is for the center channel sounds (dialog, vocals, etc.). If for some reason it is not practical to use a center speaker, you can do without it. Best results, however, are obtained with the full system. Align the front face of the center speaker with the front face of your video monitor. Place the speaker centrally between the front speakers and as close to the monitor as possible, such as directly over or under it.

11