TROUBLESHOOTING
Problem | Cause | Remedy | Refer to | |
page | ||||
|
|
| ||
|
|
|
| |
The sound suddenly | The protection circuitry has been activated | Check that the impedance selector setting is correct. | 73 | |
goes off. | because of a short circuit, etc. |
|
| |
Check that the speaker wires are not touching each | — | |||
|
| |||
|
| other and then turn this unit back on. |
| |
|
|
|
| |
| The sleep timer has turned the unit off. | Turn on the power, and play the source again. | — | |
|
|
|
| |
| The sound is muted. | Press MUTE to cancel a mute. | 31 | |
|
|
|
| |
Only the speaker on | Incorrect cable connections. | Connect the cables properly. If the problem persists, | 12 | |
one side can be |
| the cables may be defective. |
| |
heard. |
|
|
| |
Incorrect balance settings in SET MENU. | Adjust the SPEAKER LEVEL settings. | 65 | ||
| ||||
|
|
|
| |
Only the center | When playing a monaural source with a |
|
| |
speaker outputs | CINEMA DSP program, the source signal |
|
| |
substantial sound. | is directed to the center channel, and the |
|
| |
| front and surround speakers output effect |
|
| |
| sounds. |
|
| |
|
|
|
| |
No sound from the | The sound field programs are turned off. | Press STRAIGHT (EFFECT) to turn them on. | 35 | |
effect speakers. |
|
|
| |
You are using a source or program | Try another sound field program. | 55 | ||
| ||||
| combination that does not output sound |
|
| |
| from all channels. |
|
| |
|
|
|
| |
No sound from the | The output level of the center speaker is | Raise the level of the center speaker. | 65 | |
center speaker. | set to minimum. |
|
| |
|
|
|
| |
| “CENTER SP” in SET MENU is set to | Select the appropriate setting for the center speaker. | 63 | |
| NONE. |
|
| |
|
|
|
| |
| One of the HiFi DSP programs (except for | Try another sound field program. | 55 | |
| 7ch Stereo) has been selected. |
|
| |
|
|
|
| |
No sound from the | The output level of the surround speakers | Raise the output level of the surround speakers. | 65 | |
surround speakers. | is set to minimum. |
|
| |
|
|
|
| |
| “SUR. L/R SP” in SET MENU is set to | Select the appropriate setting for the surround left and | 63 | |
| NONE. | right speakers. |
| |
|
|
|
| |
| A monaural source is being played with | Press STRAIGHT (EFFECT) to turn on the sound | — | |
| STRAIGHT. | fields. |
| |
|
|
|
| |
No sound from the | Surround back speakers are not selected. | Select surround back speakers in SUR. B L/R SP. | 64 | |
surround back |
|
|
| |
“SUR. L/R SP” in SET MENU is set to | If the surround left and right speakers are set to | 63 | ||
speakers. | ||||
| NONE. | NONE, the surround back speaker setting is |
| |
|
| automatically set to NONE. Select the appropriate |
| |
|
| setting for the surround speakers. |
| |
|
|
|
| |
| “SUR. B L/R SP” in SET MENU is set to | Select LRGx1 or SMLx1. | 64 | |
| NONE. |
|
| |
|
|
|
| |
No sound from the | “LFE/BASS OUT” in SET MENU is set | Select SWFR or BOTH. | 64 | |
subwoofer. | to FRNT when a Dolby Digital or DTS |
|
| |
| signal is being played. |
|
| |
|
|
|
| |
| “LFE/BASS OUT” in SET MENU is set | Select BOTH. | 64 | |
| to SWFR or FRNT when a |
|
| |
| source is being played. |
|
| |
|
|
|
| |
| The source does not contain low bass |
|
| |
| signals. |
|
| |
|
|
|
|
86