Yamaha HTR-6130 12 En, SP IMP.- 8 MIN, SP IMP.- 6 MIN, Connecting to the FRONT A terminals

Connections

■Connecting to the FRONT A terminals

2

1	Red: positive (+)
	Black: negative (–)
	3

1Loosen the knob.

2Insert the bare end of the speaker wire into the slit on the terminal.

3Tighten the knob to secure the wire.

Connecting the banana plug

(except Europe, Russia, Korea, and Asia models)

The banana plug is a single-pole electrical connector widely used to terminate speaker cables. First, tighten the knob and then insert the banana plug connector into the end of the corresponding terminal.

Banana plug

■Connecting to the FRONT B, CENTER, and SURROUND terminals

Red: positive (+)

Black: negative (–)

1Press down the tab.

2Insert the bare end of the speaker wire into the hole on the terminal.

3Release the tab to secure the wire.

Setting the speaker impedance (U.S.A. and Canada models only)

Caution

If you are to use 6 ohm speakers, set “SP IMP.” to “6ΩMIN” as follows BEFORE using this unit.

1Make sure this unit is turned off.

See page 19 for details about turning on or off this unit.

2Press and hold J TONE CONTROL and then press A STANDBY/ON to turn on this

unit.

This unit turns on, an the advanced setup menu appears in the front panel display.

3Press K PROGRAM l / h repeatedly to select “SP IMP.”.

The following display appears in the front panel display.

SP IMP.- 8 MIN

4Press L STRAIGHT repeatedly to select “6ΩMIN”.

The following display appears in the front panel display.

SP IMP.- 6 MIN

5Press A STANDBY/ON to confirm your selection and set this unit to the standby mode.

Note

The setting you made is reflected next time you turn on this unit.

12 En