Connecting the FM and AM antennas
Both FM and AM indoor antennas are supplied with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.
Notes
•The AM loop antenna should be placed away from this unit.
•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center about outdoor antennas.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
Outdoor AM antenna |
|
|
| AM loop |
Use a 5 to 10 m (16 to 32 |
|
|
| antenna |
ft) of |
|
|
| (supplied) |
extended outdoors from a |
|
|
|
|
window. |
|
|
|
|
Connections
Assembling the supplied AM loop antenna
Note
The types of the supplied AM loop antenna is different depending on the models.
Connecting the power cable
Once all connections are complete, plug the power cable into the AC wall outlet.
PREPARATION
DEO
N DVR OUT | MONITOR | |
|
| OUT |
|
|
|
|
|
|
|
|
|
|
|
|
| DVR |
| AUDIO | CD | |
N | OUT | ||||
|
| ||||
ANTENNA
AM
GND
FM
75
UNBAL.
IN | MD/ |
(PLAY) | |
RSURRO
OUTP
OUT (REC)
Indoor FM antenna (supplied)
Power cable
(U.S.A. model)
To the AC wall outlet
Ground
For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
Connecting the wire of the AM loop antenna
Open the | Insert | Close the |
lever |
| lever |
y
The wire of the AM loop antenna does not have any polarity and you can connect either end of the wire to AM or GND terminal.
Turning on and off the power
■Turning on this unit
Press A STANDBY/ON (or DPOWER) to turn on this unit.
y
When you turn on this unit, there will be a 4 to
■Set this unit to the standby mode
Press A STANDBY/ON (or ESTANDBY) to set this unit to the standby mode.
Note
In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.
English
