Playback
■Adjusting speaker levels during
playback
You can adjust the output level of each speaker while listening to a music source.
Note
This operation will override the level adjustment made in “SP LEVEL” (see page 46).
1Press 4AMP and then press 6LEVEL repeatedly to select the speaker you want to adjust.
Display | Adjusted speaker |
FRONT L | Front left speaker |
|
|
FRONT R | Front right speaker |
|
|
CENTER | Center speaker |
|
|
SWFR | Subwoofer |
|
|
SUR.L | Surround left speaker |
|
|
SUR.R | Surround right speaker |
|
|
y
Once you press 6LEVEL on the remote control, you can also select the speaker by pressing 7k/ n.
2Press 7l / h on the remote control to adjust the speaker output level.
The control range is from
y
You can press D A/B/C/D/E to select a speaker and then
EPRESET/TUNING l/ hto adjust the speaker output level.
■Displaying the signal information
You can display the format, sampling frequency, channel, bit rate and flag data of the current input signal.
1Press 4AMP and then press HMENU on the remote control.
“BASIC SETUP” appears in the front panel display.
;BASIC SETUP
2Press 7k/ n repeatedly to select “SIGNAL
INFO” and then press 7ENTER.
3Press 7k / n to switch the displayed information.
The following information about the input source appears in the front panel display.
Display | Description |
Format | Signal format. |
|
|
Sampling | The number of samples per second taken |
frequency | from a continuous signal to make a discrete |
| signal. |
|
|
Channel | The number of source channels in the input |
| signal (front/surround/LFE). |
|
|
Bit rate | The number of bits passing a given point |
| per second. |
|
|
Flag data | Flag data encoded in DTS, Dolby Digital, |
| or PCM signals that cue this unit to |
| automatically switch decoders. |
|
|
4Press HMENU to exit.
