Setting remote control codes
You can control other components by setting the appropriate remote control codes. For a complete list of available remote control codes, refer to “List of remote control codes” at the end of this manual.
Remote control code default settings
Input | Component | Manufacturer | Default | |
source | category | code | ||
| ||||
|
|
|
| |
CD | CD | Yamaha | 5013 | |
|
|
|
| |
Yamaha | 5001 | |||
|
|
|
| |
TUNER | TUNER | Yamaha | 5007 | |
|
|
|
| |
DVD | DVD | Yamaha | 2000 | |
|
|
|
| |
DTV/CBL | — | — | — | |
|
|
|
| |
TUNER | Yamaha | 5011 | ||
OCK | ||||
|
|
| ||
|
|
|
| |
DVR | DVR | Yamaha | 2011 | |
|
|
|
| |
A | TUNER | Yamaha | 5012 | |
|
|
|
| |
B | TUNER | Yamaha | 5009 | |
|
|
|
| |
C | TUNER | Yamaha | 5017 | |
|
|
|
| |
D | — | — | — | |
|
|
|
| |
E | — | — | — | |
|
|
|
|
Note
You may not be able to operate your Yamaha component even if a Yamaha remote control code is preset as listed above. In this case, try setting another Yamaha remote control code.
1While pressing and holding one of the input selector buttons (3) on the remote control to
select the input area you want to set up, press 2AV POWER for more than 3
seconds.
A B C
CD
POWER
AV
DVD DTV/CBL DVR
E | Press for 3 |
seconds
While holding down
Remote control features
2Press the numeric buttons (0 to 9) (N) to enter the
When the setting succeeds, “RemoteSetup OK” appears; however, when it dues not, “RemoteSetup NG” appears in the front panel display.
Notes
•If the manufacturer of your component has more than one code, try each of them until you find the correct one.
•If you do not press any buttons within 30 seconds in step 2, the setup process is canceled. If this happens, repeat the setup procedure.
■Resetting all remote control codes
Use this feature to clear all the remote control codes previously set and reset all of them to the initial factory settings.
1While pressing and holding 4AMP, press 2AV POWER for more than 3 seconds.
AMP | POWER |
| |
| AV |
While holding | Press for 3 |
down | seconds |
2Press the numeric buttons (N) to enter the code number “9981”.
“RemoteSetup OK” appears in the front panel display, and the remote control codes previously set are cleared and reset to the initial factory settings.
y
If you do not press any buttons within 30 seconds after step 1, the clearing process is canceled. In this case, repeat the clearing procedure.
OPERATION | ADVANCED |
|
|
English
