Getting started
■Checking the supplied accessories
Check that you received all of the following parts.
❏Remote control
❏Batteries (2) (AAA, R03,
❏AM loop antenna
❏Indoor FM antenna
■VOLTAGE SELECTOR
(Asia and General models only)
Caution
The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.
Select the switch position (upper or lower) according to your local voltage using a straight slot screwdriver.
Voltages are
VOLTAGE
SELECTOR
110V-
120V
220V-
240V
■ Installing batteries in the remote control
1 
3
2
1Take off the battery compartment cover.
2Insert the two supplied batteries
(AAA, R03,
3Snap the battery compartment cover back into place.
Notes
•Change all of the batteries if you notice the following condition:
– the operation range of the remote control decreases.
•Do not use an old battery and a new one together.
•Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.
•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
•Do not throw away batteries with general house waste; dispose of them correctly in accordance with your local regulations.
•If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries and set up the remote control code.
INTRODUCTION
English
