153
Installing Options
CInsert the SIMMs in the SIMM slots as described below.
First SIMM
C-1 Make sure the orientation is correct.
Make sure that the cutout on the SIMM module is
aligned with the protruding “key” on the connector
slot.
WARNING
Install the SIMM modules carefully as per the procedure
outlined below (steps 3-1 through 3-3). Improper installation
can cause shorts which may result in irreparable damage
and pose a fire hazard.
Carefully remove dust and dirt.
Make sure that there is no dust or dirt on or around the
SIMM edge terminals or the connector slots before installa-
tion.
2 3 -1
Do not install the SIMM backwards.
Slot key
SIMM cutout
Do not remove the circuit board in front of the SIMM slot
(the system memory is on this board).
XRemove the six screws from the SIMM cover in the center
of the instrument’s bottom panel, and remove the cover.