Recording a source
Notes
•The audio from the current input source is output to the TAPE REC and LINE 1 REC jacks. When TAPE is selected, audio is output to the LINE 1 REC jacks only. When LINE 1 is selected, audio is output to the TAPE REC jacks only.
•This unit must be turned on in order to record.
•The VOLUME, BASS, TREBLE, BALANCE and LOUDNESS controls and the PURE DIRECT switch have no effect on the source being recorded.
•Check the copyright laws in your country before recording from records, CDs, radio, etc. Recording
INPUT selector
PLAYING AND RECORDING
Using the sleep timer
Use this feature to automatically set this unit to standby mode after a certain amount of time. The sleep timer is useful when you are going to sleep while this unit is playing or recording a source.
A(power)
SLEEP | A (power) |
OPERATION | BASIC |
Input selector buttons
FM, AM
1Rotate the INPUT selector on the front panel (or press one of the input selector buttons or FM or AM on the remote control) to select the source you want to record.
2Play the source and begin recording using the recording device connected to the REC jacks (TAPE and/or LINE 1) on the rear panel. See page 10.
Note
The sleep timer can only be set with the remote control.
1Press SLEEP repeatedly to set the amount of time before this unit is set to standby mode.
Each time you press SLEEP, the front panel display changes as shown below.
The SLEEP indicator blinks while setting the amount of time for the sleep timer.
If the sleep timer is set, the SLEEP indicator on the front panel display lights up.
y
To cancel the sleep timer, do one of the following:
•Select “Sleep Off”.
•Press A(power) on the remote control to set this unit to standby mode.
•Press A(power) on the front panel to turn off this unit.