PLAYING BACK TUNES FROM YOUR iPhone/iPod/Bluetooth™ COMPONENT
■Playing back BluetoothTM components
3 Press B / C on the remote control to select “Connect”, and then press ENTER.
When wireless connection is complete, “Connected” is displayed on the front panel display.
To exit the Option menu, press OPTION on the remote control.
MEMORY | INPUT selector |
DOCK 
B / C
ENTER
OPTION 
Note
“Not found” is displayed if there is a connection error. Check that the following conditions have been satisfied, and try to establish a wireless connection again.
•Both this unit and the Bluetooth component are paired.
•The Bluetooth component is switched on.
•The Bluetooth component is within 32 feet/10 meters of the Bluetooth wireless audio receiver.
4Operate the Bluetooth component for playback.
While the Bluetooth component is playing, “BLUETOOTH” is displayed on the front panel display.
Note
To disconnect a wireless connection, repeat these steps and select “Disconnect” in step 3.
When pairing is complete, carry out the following procedure to achieve a wireless connection between this unit and the Bluetooth component.
When the wireless connection is complete, you can enjoy playback from Bluetooth components.
y
When the input source is set to DOCK, you can also establish a wireless connection by pressing MEMORY on the front panel (or ENTER on the remote control).
Note
Depending on the Bluetooth component, a wireless connection is established automatically or when the Bluetooth component is operated. In these cases, it is not necessary to carry out the following procedure.
1Rotate the INPUT selector on the front panel (or press DOCK on the remote control) to select DOCK as the input source.
2Press OPTION on the remote control.
The Option menu for DOCK displayed (see page 29).