Using RP-U100 Application Software

This section explains how to install the RP-U100 Application Software, which can be used to control the RP-U100 from a PC running Windows 98. Instructions for using the RP-U100 Application Software are available as online help.

System Requirements

•A computer with a 200 MHz or faster Intel Pentium MMX processor or equivalent

•At least 32 MB of RAM (64 MB or more recommended)

•A hard disk with at least 20 MB of free space

•A CD-ROM or DVD-ROM drive (installation only)

•A VGA monitor (640 ⋅ 480, 256 color minimum)

•A USB port (USB Ver 1.0 compatible)

•Windows 98

Installing the RP-U100 Application Software

This section explains how to install the RP-U100 Application Software.

Installation Notes

•Make sure that the USB cable is dis- connected from the RP-U100.

Do not connect the RP-U100 to the PC’s USB port until the installation is complete, as the driver software will not be installed correctly and you will have to install it again, as explained on page 18.

•Make sure that your PC meets the sys- tem requirements listed previously.

•You may be requested to insert your Windows 98 CD-ROM during the installation, so have it ready before commencing.

1.Turn on your PC and, if it’s not run- ning already, start Windows 98.

2.Insert the YAMAHA RP-U100 CD-ROM into the CD-ROM or DVD-ROM drive.

If the Windows 98 Autorun feature is turned on, the installation start up screen appears automatically.

3.Continue with the installation as prompted.

If the Windows 98 Autorun feature is not turned on, you must start the installation manually, as explained below.

4.Double-click the My Computer icon. The My Computer window opens.

5.Double-click the “Yamaha rp-u100” CD-ROM icon.

The installation start up screen appears.

6.Continue with the installation as prompted.

16