Opening Page

27/68 ページ

Power

STANDBY

ON

Status

AC power cord is connected and unit power switch or Application power button was set to STANDBY.

AC power cord is connected and unit power switch or Application power button was set to ON.

Main Panel (Standby) details

Main Panel (On) details

Power Off

 

OFF

AC power cord is disconnected.

Volume

Volume Control

Volume control

Drag the volume indicator dot around the circumference of the DSP button.

When the volume indicator is selected, the green dot becomes red.

To increase the volume, drag the dot clockwise. To decrease the volume, drag the dot counterclockwise.

Using the Setup Dialog, you can set the upper volume limit for the volume as adjusted with the application. This helps to prevent excessively loud settings made by mistake.

If the volume control on the RP-U100 main unit was used to set the volume to a level higher than the upper limit for the application, the volume will return to the upper limit setting the next time the volume control of the application is used.

Note that the volume may sometimes jump up suddenly when the dot on the application is moved. You should therefore pay attention to the MAX VOLUME POSITION on the setup dialog.

Setup Dialog details