1 2 3 4 5 6 7 8 9 Automatic speaker setup

Error messages

If any error message is displayed during the measurement, resolve the problem and perform YPAO again.

Error message

Cause

Remedy

 

 

 

E-1: No Front SP

Front speakers are not detected.

 

 

 

 

E-2: No Sur. SP

One of the surround speakers cannot be detected.

Follow the on-screen instructions to exit YPAO, turn off the unit, and then check the speaker connections.

 

 

 

E-3: No F.PRNS SP

One of the front presence speakers cannot be detected.

 

 

 

 

E-4: SBR → SBL

A surround back speaker is connected to the R side only.

When using only one surround back speaker, you need to connect it to the SINGLE jack (L side). Follow the

on-screen instructions to exit YPAO, turn off the unit, and then reconnect the speaker.

 

 

 

 

 

E-5: Noisy

The noise is too loud.

Keep the room quiet and follow the on-screen instructions to start the measurement again. If you select

“PROCEED”, YPAO takes the measurement again and ignores any noise detected.

 

 

 

 

 

E-6: Check Sur.

Surround back speakers are connected, but no surround

Surround speakers need to be connected in order to use surround back speakers. Follow the on-screen

speakers are connected.

instructions to exit YPAO, turn off the unit, and then reconnect the speakers.

 

 

 

 

E-7: No MIC

The YPAO microphone has been removed.

Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the

measurement again.

 

 

 

 

 

 

 

Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the

E-8: No Signal

The YPAO microphone cannot detect test tones.

measurement again. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service

 

 

center.

 

 

 

E-9: User Cancel

The measurement has been canceled.

Follow the on-screen instructions to start the measurement again. To cancel the measurement, select “EXIT”.

 

 

 

E-10: Internal Error

An internal error has occurred.

Follow the on-screen instructions to exit YPAO, turn off and on the unit. If this error occurs repeatedly, contact

the nearest authorized Yamaha dealer or service center.

 

 

 

 

 

PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO)

En 47