CONNECTIONS
1Remove approximately 10 mm of insulation from each of the speaker cables.
10 mm
2Twist the exposed wires of the cable together to prevent short circuits.
3Loosen the knob using the supplied speaker terminal wrench.
Speaker terminal wrench
Red: positive (+)
Black: negative (–)
4Insert one bare wire into the hole on the side of each terminal.
Red: positive (+)
Black: negative
5Tighten the knob to secure the wire using the supplied speaker terminal wrench.
Speaker terminal wrench
Red: positive (+)
Black: negative
6Hook the speaker terminal wrench onto WRENCH HOLDER on the rear panel of this unit when not in use.
16