ZONE 2/ZONE 3
■Using the internal amplifiers of this unit
If you want to use one internal amplifier (surround or surround back) of this unit
Connect the Zone 2 or Zone 3 speakers directly to the SURROUND/ZONE 2(3) or PRESENCE/ZONE 2(3) speaker terminals and select either SUR or PRNS for ZONE2 AMP or ZONE3 AMP (see pages 80 and 81).
If you want to use two internal amplifiers (both surround and surround back) of this unit
Connect the Zone 2 or Zone 3 speakers directly to the SURROUND/ZONE 2(3) and PRESENCE/ZONE 2(3) speaker terminals and select BOTH for ZONE2 AMP or ZONE3 AMP (see pages 80 and 81).
Third room
|
| SURROUND/ZONE 2(3) |
|
|
|
| |
R | + | – | – | + | L | R | L |
|
|
|
| ||||
|
|
|
|
|
| + |
|
R + | – | – | + L |
|
| ||
|
|
|
|
|
| – |
|
|
|
|
|
|
| PRESENCE/ ZONE 2(3) | |
|
|
| SINGLE |
|
|
|
|
|
| SURROUND BACK |
|
|
|
| |
Second room
This unit
IMPORTANT SAFETY NOTICE
SURROUND/ZONE 2(3) or PRESENCE/ZONE 2(3) speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low impedance load resulting in amplifier damage. See this owner’s manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This information is found on the back panel of your Receiver.
Selecting Zone 2 or Zone 3 | 2 Press ZONE CONTROL on the front panel | |
You can select the zone you want to control by using the | repeatedly to select the zone you want to | |
control. | ||
control buttons on the front panel or on the remote control. | ||
| ||
Once the zone you want to control is selected, you can | ZONE CONTROL | |
control the selected zone as described in “Controlling | ||
| ||
Zone 2 and Zone 3” on page 99. |
|
■Front panel operations
1Press MAIN ZONE ON/OFF, ZONE 2 ON/OFF or ZONE 3 ON/OFF on the front panel to individually turn on this unit, Zone 2 or Zone 3.
Press each button repeatedly to turn on the respective zone or set it to the standby mode.
Each time you press ZONE CONTROL, the front panel display changes as shown below, and the indicator for the currently selected zone flashes for approximately 5 seconds. However, no indicator flashes when this unit is selected.
ZONE2 ZONE3
No indicator flashes when this unit is selected.
ZONE ON/OFF
ON/OFF
ZONE ZONE
y
Once MASTER ON/OFF on the front panel is pressed inward to the ON position, you can also press POWER and STANDBY on the remote control to turn on this unit, Zone 2 and Zone 3 simultaneously.
ZONE2
Controls the Zone 2 component connected to the ZONE 2 AUDIO L/R jacks on the rear panel of this unit.
ZONE3
Controls the Zone 3 component connected to the ZONE 3 AUDIO L/R jacks on the rear panel of this unit.
98
