REMOTE CONTROL FEATURES

5 Press LEARN again to exit from the setup mode.

LEARN

Notes

Supplied remote control does not store all the manufacturer codes for commercially availabvle AV components (including Yamaha AV components). Therefore it may not work to operate your AV component. If operation is not possible with any of the manfacturer codes, program the new remote control function with the Learn feature or use the remote control for the component.

If you have already programmed a remote control function for a button, the function by learning programming takes priority over the setup manufacturer code’s function.

“ERROR” appears in the display window when pressing buttons other than indicated in each step, or more than one button at once.

3 Place this remote control and the other remote control about 5 to 10 cm apart on a flat surface so that their infrared transmitters are aimed at each other.

SOURCE

ENTER

TITLE

1VCRVCR2/DVRCBL/SAT TV/LD-D

R-CDMD/TAPETUNERAUX-V

SYSTEM POWER

MACROLEARNCLEAR NAME-RE TRANSMIT

 

BA

 

 

 

 

 

 

STANDBY

 

 

 

 

INPUT 6CH

DVD

CD

PHONO

ON OFF

MACRO

5 to 10 cm (2 to 4 inch)

4 Press LEARN by using a ballpoint pen or similar object.

Do not press and hold LEARN longer than three seconds. Otherwise this unit enters the manufacturer code setting mode.

Learn Feature

If you want to program functions not included in the basic operations covered by the manufacturer code, or a manufacturer code is not available, the following procedure needs to be performed. The possible programming area is the same as a component control area, so the buttons are programmable independently for each source component area.

Note

This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of the other remote control’s functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for the other remote control.)

Programming a new remote control function

1 Set 10KEY/DSP to 10KEY. 10KEY DSP

LEARN

Flashes alternately

Notes

Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press LEARN again.

Do not press and hold LEARN longer than 3 seconds. Otherwise this unit enters the manufacturer code setting mode.

5 Press the button for which you want to program the new function.

“LEARN” is displayed.

ENTER

TITLE

TV/LD-D

AUX-V

SYSTEM POWER

TRANSMIT

1VCRVCR2/DVRCBL/SAT

R-CDMD/TAPETUNER

BA

MACROLEARNCLEAR NAME-RE

 

 

 

 

STANDBY

 

 

INPUT 6CH

DVD

CD

PHONO

MACRO ON OFF

Notes

It is also possible to program in the control area of this unit with 10KEY/DSP set to DSP. However, if you program functions in this area, you cannot control this unit and select a DSP program.

2 Press an input selector button, Å or ı to select a source component.

 

 

A

B

PHONO

V-AUX

TUNER

MD/TAPE

CD-R

CD

D-TV/LD

CBL/SAT

VCR 1

VCR2/DVR

DVD

48