2 LOW FRQ TEST

Use this feature to adjust the output level of the subwoofer so it matches that of the other speakers in your configuration. Change the setting with the remote control while sitting in the listening position.

1 Press –/+ to set “TEST TONE” to ON, and adjust the volume with VOLUME +/– so you can hear the tone.

2 LOW FRQ TEST

T E S T T O N E … … … … O N O U T P U T … M A I N L / R F R Q … … … … … … … … 8 8 H z

Notes

Do not turn up the volume too high.

If no test tone is heard, turn down the volume, set this unit in the standby mode and make sure all the necessary connections are correct.

2 Press n to go to “OUTPUT” and press –/+ to select the speaker you want to compare with the subwoofer.

If SWFR is selected, the test tone above 90 Hz will not be output from the subwoofer. The test tone will not necessarily be output from the selected speakers. The output mode of the test tone depends on the settings of “1 SPEAKER SET” on the SET MENU.

2 LOW FRQ TEST

T E S T T O N E … … … O F F

O U T P U T … M A I N L / R F R Q … … … … … … … … 8 8 H z

3 Press n to go to “FRQ” and press –/+ to select the frequency you want to use.

2 LOW FRQ TEST

T E S T T O N E … … … O F F O U T P U T … M A I N L / R ≥ F R Q … … … … … … … … 8 8 H z

SET MENU

4 Adjust the volume of the subwoofer with the controls on the subwoofer so it matches that of the speaker you are comparing it to.

About the test tone

The test tone is produced by the tone generator. The tone generator produces a narrow-band noise centered on a specified frequency by the band pass filter beside a wide-band noise.

You can change this center frequency from 35 Hz through 250 Hz in one-sixth octave steps.

You can use the test tone not only for adjusting the subwoofer level, but also for checking the low-frequency characteristics of your listening room. Low-frequency sounds are especially affected by the listener’s position, speaker placement, subwoofer polarity and other conditions.

Digital generator

(wide band noise produced)

Noise

Freq.

Center freq. 35 Hz – 250 Hz

Band pass filter

3L/R BALANCE (balance of the left and right main speakers)

Use this feature to adjust the balance of the output level from the left and right main speakers.

Control range: 10 steps for L/R

Initial setting: 0 dB for L/R

Press + to decrease the output level for the left main speaker. Press – for the right main speaker.

3 L/R BALANCE

L…………………… ……………………R

0

-/ + : A d j u s t

/ : E x i t

OPERATION

ADVANCED

 

 

English

65