REMOTE CONTROL FEATURES
4 Press MACRO again when the operation sequence you want to program is complete.
Note
MACRO
2 Press k / n to select the clear mode.
The mode is shown in the display window in the following order:
(L: name of a component) Clears all learned functions for the
•“ERROR” appears in the display when pressing butons other than indicated in each step, or more than one button at once.
Memory
If the remote control is without batteries for more than 3 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries, set up the manufacturer code and program any acquired functions that may have been cleared.
Clearing Learned Functions,
Macros, Renamed Source Names,
and Setup Manufacturer Codes
1 Press CLEAR by using a ballpoint pen or similar object.
CLEAR
Note
•Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press CLEAR again.
component area. Press the input selector button, Å or ı to select the component.
Clears all learned functions for this unit control area.
Clears all learned functions.
Clears all programmed macros.
Clears all renamed source names in the display window.
Clears all programmed functions including setup manufacturer codes. This returns to the factory settings.
3 Press and hold CLEAR again for about 3 seconds.
“C:OK” appears in the display window.
CLEAR
Note
•“C:NG” appears in the display window if the operation is unsuccessful. In this case, start over from step 2.
4 Press CLEAR to exit from the clearing mode.
Once you have cleared a learned function or macro for a button, the button reverts to the factory setting.
CLEAR
Note
•“ERROR” appears in the display window under the following circumstances:
–when pressing a button other than the cursor and ENTER;
–when pressing more than one button at once; or
–when MACRO ON/OFF, 10KEY/DSP or PARAMETER/SET MENU is switched to another position.
52