How to connect
Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage this unit and/or speakers.
English
For connecting to the MAIN SPEAKERS terminals
For connecting to the REAR and CENTER SPEAKERS terminals
Red: positive (+)
Black: negative
1Unscrew the knob.
2 Insert the bare wire. [Remove approx. 5 mm (1/4”) insulation from the speaker wires.]
3 Tighten the knob and secure the wire.
Red: positive (+)
Black: negative
1Press the tab.
2Insert the bare wire. [Remove approx. 5 mm (1/4”) insulation from
the speaker wires.]
3Release the tab and secure the wire.
Banana plug connections are also possible (except for Singapore model). Simply insert the banana plug connector into the corresponding terminal.
19
19 | 6/23/99, 4:09 PM |