19For US customers only:

Outdoor Antenna Grounding – If an outside antenna is connected to this unit, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides informa- tion with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

EXAMPLE OF ANTENNA GROUNDING

MAST

ANTENNA

 

LEAD IN

 

WIRE

GROUND

 

CLAMP

 

 

ANTENNA

 

DISCHARGE UNIT

 

(NEC SECTION 810–20)

ELECTRIC

 

SERVICE

 

EQUIPMENT

GROUNDING CONDUCTORS

 

 

(NEC SECTION 810–21)

 

GROUND CLAMPS

 

POWER SERVICE GROUNDING

 

ELECTRODE SYSTEM

 

(NEC ART 250. PART H)

NEC – NATIONAL ELECTRICAL CODE

 

English

FCC INFORMATION (for US customers only)

1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT!

Compliance with FCC regulations does not guarantee

This product, when installed as indicated in the

that interference will not occur in all installations. If this

instructions contained in this manual, meets FCC

product is found to be the source of interference, which

requirements. Modifications not expressly approved by

can be determined by turning the unit “OFF” and “ON”,

Yamaha may void your authority, granted by the FCC,

please try to eliminate the problem by using one of the

to use the product.

following measures:

2. IMPORTANT : When connecting this product to

Relocate either this product or the device that is being

accessories and/or another product use only high

affected by the interference.

quality shielded cables. Cable/s supplied with this

 

product MUST be used. Follow all installation instruc-

Utilize power outlets that are on different branch (circuit

tions. Failure to follow instructions could void your FCC

breaker or fuse) circuits or install AC line filter/s.

authorization to use this product in the USA.

In the case of radio or TV interference, relocate/reorient

3. NOTE : This product has been tested and found to

the antenna. If the antenna lead-in is 300 ohm ribbon

comply with the requirements listed in FCC Regula-

lead, change the lead-in to coaxial type cable.

tions, Part 15 for Class “B” digital devices. Compliance

 

with these requirements provides a reasonable level of

If these corrective measures do not produce satisfac-

assurance that your use of this product in a residential

tory results, please contact the local retailer authorized

environment will not result in harmful interference with

to distribute this type of product. If you can not locate

other electronic devices.

the appropriate retailer, please contact Yamaha

This equipment generates/uses radio frequencies and,

Electronics Corp., U.S.A. 6660 Orangethorpe Ave,

Buena Park, CA 90620.

if not installed and used according to the instructions

 

found in the users manual, may cause interference

The above statements apply ONLY to those products

harmful to the operation of other electronic devices.

distributed by Yamaha Corporation of America or its

 

subsidiaries.

We Want You Listening For A Lifetime

YAMAHA and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion – and, most importantly, without affecting your sensitive hearing.

Since hearing damage from loud sounds is often undetectable until it is too late, YAMAHA and the Electronic Industries Association’s Consumer Electronics Group recommend you to avoid prolonged exposure from excessive volume levels.

3

01RX-V595-e/f1

3

6/23/99, 4:09 PM