|
|
|
| English |
| SYMPTOM | CAUSE | REMEDY | |
|
| |||
|
|
|
|
|
| FM stereo reception is noisy. | Because of the characteristics of FM | Check the antenna connections. |
|
|
| stereo broadcasts, this is limited to | Try using a high quality directional FM |
|
|
| cases where the transmitter is too far | antenna. |
|
|
| away or the antenna input is poor. | Set TUNING MODE to the manual |
|
|
|
| tuning mode. |
|
|
|
|
|
|
FM | There is distortion and clear | There is multipath interference. | Adjust antenna placement to eliminate |
|
reception cannot be obtained even |
| multipath interference. |
| |
|
|
| ||
| with a good FM antenna. |
|
|
|
|
|
|
|
|
| The desired station cannot be tuned | The station is too weak. | Use the manual tuning method. |
|
| in with the automatic tuning method. |
| Use a high quality directional FM |
|
|
|
| antenna. |
|
|
|
|
|
|
| Previously preset stations can no | This unit has been unplugged for a long | Repeat the presetting procedure. |
|
| longer be tuned in. | period. |
|
|
|
|
|
|
|
| The desired station cannot be tuned | Weak signal or loose antenna | Tighten the AM loop antenna |
|
| in with the automatic tuning method. | connections. | connections and rotate it for best |
|
|
|
| reception. |
|
|
|
|
|
|
AM |
|
| Use the manual tuning method. |
|
|
|
|
| |
There are continuous crackling and | Noises will result from ligtning, | Use an outdoor antenna and a ground |
| |
| hissing noises. | fluorescent lamps, motors, thermostats | wire. This will help somewhat but it is |
|
|
| and other electrical equipment. | difficult to eliminate all noise. |
|
|
|
|
|
|
| There are buzzing and whining | A television set is being used nearby. | Relocate this unit away from the TV. |
|
| noises (especially in the evening). |
|
|
|
|
|
|
|
|
transmitter | The remote control transmitter does | Direct sunlight or lighting (of an inverter | Change the position of the main unit. |
|
not work. | type of fluorescent lamp etc.) is striking |
|
| |
|
|
| ||
|
| the remote control sensor of the main |
|
|
|
| unit. |
|
|
|
|
|
|
|
control |
| The manufacturer’s code is not set | Set the code again. |
|
| properly. |
|
| |
|
|
|
| |
|
|
|
|
|
|
| The proper manufacturer’s code for the | Try entering another code for the same |
|
Remote |
| component to be controlled is not set. | manufacturer. |
|
|
|
|
| |
| The component to be controlled is not | Set the SELECTOR DIAL to the proper |
| |
| selected. | position. |
| |
|
|
|
|
|
Others | The sound is degraded when | This unit is in the standby mode. | Turn the power of the unit on. |
|
listening with headphones to a |
|
|
| |
|
|
|
| |
| CD player or tape deck that is |
|
|
|
| connected to this unit. |
|
|
|
|
|
|
|
|
53
53 | 6/23/99, 4:12 PM |