REMOTE CONTROL TRANSMITTER

You can use this remote control transmitter to control not only this unit but also other components connected to it. This is factory set to control this unit and most YAMAHA audio components. To control other brands of components, you must preset the remote control transmitter with the manufacturer’s codes listed from page 108.

Components which can be controlled

There are nine positions that you can select to control connected components with this remote control transmitter. When turning the SELECTOR DIAL, the position changes as follows:

English

AMP/TUN:

You can perform basic operations of this unit with the SELECTOR DIAL set to this position.

TV:

A television can be controlled.

CBL/DBS:

A cable television or DBS tuner can be controlled.

VCR:

A VCR can be controlled.

Notes

SELECTOR

DIAL

TAPE/MD:

The code for a YAMAHA tape deck is preset.

(Be sure to preset the proper code when operating a YAMAHA MD recorder.)

CD:

The code for a YAMAHA CD player is preset.

DSP:

This unit can be controlled and DSP programs can be selected directly.

DVD/LD & DVD MENU:

An LD player can be controlled using the DVD/LD position. A DVD player can be controlled using the DVD/LD and DVD MENU position. When using the YAMAHA DVD player (DVD-1000 or DVD-S700), be sure to preset the code number “4490”.

1.The shaded positions in the diagram above indicate that you can preset the code for the manufacturer of your component. Note that you can preset only one code for one position. For details, see “SETUP CODES” on page 50.

2.The DVD/LD and DVD MENU positions

•Be sure that the SELECTOR DIAL is set to the DVD/LD position when presetting the code for a DVD or an LD player. The code that you preset to the DVD/LD position is also preset to the DVD MENU position simultaneously. You cannot preset the code for a DVD player when the SELECTOR DIAL is set to the DVD MENU position.

•DVD MENU operations cannot be performed for some DVD players.

3.When using a second (and third) VCR (For details, see “To use a second (and third) VCR” on page 50.)

•If you are not using a CBL/DBS (cable TV or DBS tuner), the second (or third) VCR can be preset using the CBL/DBS position.

•If you are not using a DVD player, the second (or third) VCR can be preset using the DVD MENU position. Note that in this case you must preset a code for an LD player to the DVD/LD position even if an LD player is not used.

Basic Operations

1 Select the component that you want to control by turning

2 Press the desired operation button.

the SELECTOR DIAL.

Note: Press the button with the remote control transmitter

Note: Turn the SELECTOR DIAL until it stops with a click.

aimed at the front panel.

The component name is displayed in this window.

Indicator

The indicator will flash when the button is pressed.

45

01RX-V595-e/f6

45

6/23/99, 4:11 PM